Quantcast
Jump to content


2008 Arctic Cat 700 need some help


exramboatv

Recommended Posts

ok i have a 2008 700 acrtic cat efi.. i was ridein it came back to camp site. for only a few mins got back on and went to turn key back on and no power to dash box or motor.. turn the key to lights and they came on.. what i have tryed is unhooking the battey for a hour and hooking it back up but still no power to anything but light. and its a new battiey and even ck to make sure that it was not the prom, it wasnt. i really dont want to put it in the shop and pay 500 just for them to tell me whats wrong and i have to pay more for the part and so on.. maybe someone out there has had the same thing happen or knows what it maybe.. like one of the two back boxs under the seat...what i was thinking.

Link to comment
Share on other sites

Besides the fuses and other easy stuff, make sure you have power to the ignition wire on the coil (Under the seat)

Check the front of the quad right where the steering stem goes down from the pod right around the metal clip for wires that have rubbed thru. This is the easiest place to start.

If that doesn't work pull the rear plastics and check for an ignition wire rubbing on the frame right where they come from the fuse box and wrap around the frame to run along the chassis. This is a known problem and the most common fix.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Its-always-something
      Have a 1998 AC 300 2x4, Just installed a new carburetor. Engine starts easy but the choke RPMs are very hi and take along time (5-10 mins when cold out). After engine has warmed up choke releases and it idles and runs fine., It does no have an electric choke. The choke lever is never used and it seems like an auto choke? Long story short, how can I lower the choke rpm levels?
       
      Also, carb came with a spare145 jet, not 100% sure what is installed. Could this impact choke RPMs?
       
       
      Any help and information greatly appreciated.
    • By DrtyGrlKristin
      Just thought I'd start a new thread for newbies to the site!
      If you're new here, tell us who you are, where you're from and what you ride!!!
      Lets get to know each other a little better shall we?
      I'm not new to the site, obviously, but...
      I'm Kristin from Denver!!! I ride a 2008 Yamaha Rhino. She's my muddy baby!!!!!! Several aftermarket parts on her. She's good to me! We try and ride every weekend. This weekend we're off to MOAB! :woot:
    • By DarkRider
      This is something I'm extremely curious about. Has anyone ever attempted to buy a quad (or any other vehicle) from an impound lot? I've always wondered if this could be a bargain, or a waste of time. Google searches do turn up some helpful results. Looks like the state of NJ holds auctions online which I'd be a bit hesitant about.
       
      My online searches haven't really turned up any results of anyone buying an ATV this way. I'd be really curious if anyone tried this, or knows someone who has. I've actually found a couple pages with online auctions for my state, but none had ATVs.
    • By alexwv1863
      I have a 2016 Arctic Cat 500 and recently noticed some oil leaking on the engine block to the right of the oil filter. It's near two metal lines going in and out of the engine block. I think one of the lines is called an engine oil line. I have a photo I'm going to try and attach. Any help would be greatly appreciated. I don't want to start tearing into the engine if I don't have to. I think maybe a gasket or something blew around one of these lines. The ATV runs fine otherwise. Doesn't overheat or anything.

    • By Sofaspud
      My 2008 can-am Outlander 800r is having hard shifting issues. Does anyone have a fix for this ?
×
×
  • Create New...