Quantcast
Jump to content


Diagnostics - Bad Voltage Regulator (2007 Arctic Cat 700 EFI)

Resurgence Small Engine Inc.
 Share

Recommended Posts

Resurgence Small Engine Inc. Explorer

Resurgence Small Engine Inc.

Posted
Posted

Diagnostics - Bad Voltage Regulator (2007 Arctic Cat 700 EFI)

In this video, Jonathan investigates a client's observation that he has had to replace the battery every 2 years on his 2007 Arctic Cat 700.

Watch the video to follow Jonathan's diagnostic process.

 

Thanks for watching!

Resurgence Small Engine Inc.

Link to comment
Share on other sites
mikeexplorer Experienced

mikeexplorer

Posted
Posted

The video showed with the machine running "Volt" was flashing on the display. It will show when voltage is out of range, either hi or low.

I would think the machine owner would be seeing this and apparently did nothing about it since the video mentioned he has to replace his battery every two years. With the regulator putting out too much voltage, he is frying the battery.

Mike

 

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
 Share
Go to topic listing

  • Similar Forum Topics

    • Its-always-something
      98 arctic cat 300 2x4 hi rev choke when started
      By Its-always-something
      Have a 1998 AC 300 2x4, Just installed a new carburetor. Engine starts easy but the choke RPMs are very hi and take along time (5-10 mins when cold out). After engine has warmed up choke releases and it idles and runs fine., It does no have an electric choke. The choke lever is never used and it seems like an auto choke? Long story short, how can I lower the choke rpm levels?
       
      Also, carb came with a spare145 jet, not 100% sure what is installed. Could this impact choke RPMs?
       
       
      Any help and information greatly appreciated.
    • alexwv1863
      2016 Arctic Cat 500 Oil Leak
      By alexwv1863
      I have a 2016 Arctic Cat 500 and recently noticed some oil leaking on the engine block to the right of the oil filter. It's near two metal lines going in and out of the engine block. I think one of the lines is called an engine oil line. I have a photo I'm going to try and attach. Any help would be greatly appreciated. I don't want to start tearing into the engine if I don't have to. I think maybe a gasket or something blew around one of these lines. The ATV runs fine otherwise. Doesn't overheat or anything.

    • p5200
      New battery suggestions
      By p5200
      Hello folks, I have a Polaris 500 Scrambler. Not positive I need a new battery.  The folks I got the ride from said they put a new battery on it right before selling it to me. It's been a couple cold months before I tried starting it. After jumping it now, I let it idle plus revved it quite a bit for about 20 minutes. Then I shut it off and tried to restart barely turns over and that's it? Am I not giving it enough charge time maybe need to actually ride it? The battery on it is a Continental CTX9-BX. I lf a new battery is needed would maybe Amazon have a decent one? Thanks!
    • Werewolf
      2007 sportsman 450- one spark only
      By Werewolf
      My wheeler originally had a fuel leak.But on trying to start it no spark. Took front end off, when I try to start it I get one spark then nothing. Come back a while latter one spark,replaced coil and cdi box no help?
    • Johnfj44
      Newby in Nashville - Kawasaki Prairie 700
      By Johnfj44
      Trying to find service manual instructions on reset of belt light on 2004 Kawasaki Prairie 700. I tried YouTube and none of the videos seem to match the wiring configuration on mine. It is running rough and the only issue I can find is that the belt light is blinking to remind me to service the machine. I can do the service but don't see how to reset the light. Can anyone provide the appropriate pages of the 2004 service manual for me? 

COMMUNITY SECTIONS

ATV FORUMS

QUADCRAZY MEMBERSHIP

Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?

SIGN UP TODAY

ADVERTISE WITH US

FOLLOW US ON

  • Automotive Webmaster
×
×
  • Create New...