Quantcast
Jump to content

Recommended Posts

Posted (edited)

Have a 400 4×4 have cleaned carb niow when u start it u have to have choke on and when u kick the choke off the engine speeds up then dies like it's not getting fuel plz helo

Edited by Ajmboy
Added ATV info into topic title
  • Ajmboy changed the title to Polaris 400 4x4 Idling issue
Posted

Have you checked the fuel from the tank to make sure your flowing? Shut off valve, filter or screen inside the tank if there’s one? The fuel air mixture screw set properly? What did you set it at? 

If all above is good then sounds like a typical cleaning that was done but something was left behind. Go back and take the carb off, open it up and double check everything!  Make sure your reassembly of the choke was done correctly, the float was set at the proper height and the the fill  needle that allows fuel to enter the carburetor connected to the float has no junk in the port or on the needle itself.  Blow all the ports out with a little air pressure.  

When an engine starts to rev up it’s mimicking a choke condition starving for fuel.   

Not saying you did a bad job but sh** happens. I’ve done it and gone back before to find out that when I put the carb back on it worked fine. 

 

  • 2 years later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By realpilot
      I am unable to find a wiring diagram for this UTV.  When I turn the switch to on, the contractor does not engage.  The Brake pressure switch and the parking brake switches work correctly. What else should I be looking for?  All of the diagrams I have found are for newer models and the wire color coding is different.
       
      Thanks
    • By OldATVowner
      Just getting into this issue really. Been replacing solenoids but now I'd like to track down the problem. This time I'm not getting neutral/reverse lights or start button. Was on a creek ride when it started doing this recently. It cranks by arcing the solenoid and gives me no light or start button but if I crank with the pull cord....the neutral light and the button work. Turn it off and try to crank with the key and nothing. I'm looking into the safety switch issue tomorrow and re charging the battery. Just figured this was odd enough of a problem that you guys might be familiar. Thanks
    • By quadcrazy
      What is your take on ATV Insurance? Do you have ATV Insurance? If so, through which company and why?
      We'd like to hear our member's opinions on ATV Insurance. Please vote on the poll.
    • By rjsummer
      Just picked up an 84 LT185 ATV, I understand there was an accessory add  on that gave it electric start, anyone have any info about that kit? 
    • By Rockbottom
      2008 400 big bear was running now will not start
      have power to relay, in neutral, press start have power to starter but nothing happens starter does not turn
      i have good ground at battery to frame and added ground from wire harness to frame beside batter/ frame ground
      blue white wire to cdi has power with key on
      I believe the neutral lock out is working since is was before i shut it down
      if i put  it in gear and hit the start button with key on the relay does not click or send power the starter
      The 3 wires at the relay have power with key on
      What should i test next?
      thanks ahead
×
×
  • Create New...