Quantcast
Jump to content


660 raptor problem


Recommended Posts

To start, I would visually inspect the starter gear and flywheel. If you can't see anything obvious just by looking at it, then turn it over while it is exposed and see if you notice anything. Pull the spark plug boot off so it doesn't start while you have the side cover off. The problem could also be timing related, check the flywheel key, if it sheared off then the plug will spark at the wrong time and could cause combustion too early and stop the motor from turning.

Link to comment
Share on other sites

To start, I would visually inspect the starter gear and flywheel. If you can't see anything obvious just by looking at it, then turn it over while it is exposed and see if you notice anything. Pull the spark plug boot off so it doesn't start while you have the side cover off. The problem could also be timing related, check the flywheel key, if it sheared off then the plug will spark at the wrong time and could cause combustion too early and stop the motor from turning.

Well said.

My friend has 04 660 Raptor, when he goes to start it, it has a hard time starting. It continuously turns over and this something sound like it hits hard and binds up. A loud clanking noise. Is this maybe the flywheel/starter problem? Need help asap. Thanks.

Hard time starting, does it eventually start? If it does, how does it run once it starts. If it never starts, pull that spark plug out and check it. Check your spark.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Spritee1
      having an issue with the unit when running under a load up a hill or in high gear, seems like the belt is slipping, there is a clapping sound coming from the primary clutch like it releases and snaps back in. i don't think I should have a noise like that. this is a friends unit and he has already replaced the primary twice with the same result.
      not sure where to look next
    • By semicolon
      Hi, I am having issues with my TRX350D fuel pump.  It suddenly stopped running so I have replaced all the fuses and cleaned all the terminals.  I have fitted a new pump, fuel cut-off relay and rectifier.  Still nothing!!  The pump runs when attached to a battery.  The engine will start on the choke and the filter fills with fuel but it will  not rev and dies when the choke is closed. I have power to the relay but nothing at the pump black/white wire when cranking the engine.  Any ideas where to go from here would be very much appreciated!!
       
    • By NZrider
      My king quad 700 runs rough when cold then won't start some times but not often when it's hot. And occasionally smoke's a lot when it's cold I'm guessing that's rings but I'm worried unless it's causing the other problems
       
       
       
      All help is appreciated thanks
    • By hardcastle
      My friends KQ 300 starts fine and runs, as soon as you put it in gear and try to accelerate its bucks and farts like crazy, not moving... I cleaned carb and it worked good for 1 day... now back to same problem.... could it be such as a bent valve????
    • By bighoss
      i got my son new outlaw 50 a few weeks ago and we went rideing yesterday and while we were riding it died and it took me like 10 min to get started back and it died agen when we got close to truck so i pulled it back took the plug out it looked like it was drop in a bucket of gas took the air filter out and the ait box was full of gas also got home it started rite up today i started it it starter up but was blowing what look like water out of the exholst let it idel for a lil bit did not die but as soon as hit the gas and let off it will die what does that sound like i thnk i going to take it back to dealer and tell them to fix it as it is under warrenty but would like to know what it could be first
×
×
  • Create New...