murano22s

Need a Little Help 2003 Suzuki LTZ400

Recommended Posts

I just bought an 03 ltz400 and I changed the oil, but I cannot find a dipstick or clear view place to check oil level, the dealer told me how much to put in, but what if its burning oil and I dont know any help would e greatly appreciated.

Share this post


Link to post
Share on other sites
  •  Like what you are reading? Please help us by sharing this content.


Put in the correct amount of oil then find a long narrow object to dip into the filler hole, mark the level of the oil on said object, that will give you a reference point you can use later to make sure you haven't lost any oil. A wooden ka-bob stick works really well.

Share this post


Link to post
Share on other sites
  •  Like what you are reading? Please help us by sharing this content.

The dipstick should be there, do you have just a "screw-in" cover on the oil fill and no dipstick?

Below is an image of what it should look like.

The oil level should be to the top of the crosshatch area on the dipstick.

05.jpg

Share this post


Link to post
Share on other sites
  •  Like what you are reading? Please help us by sharing this content.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  •  Like what you are reading? Please help us by sharing this content.
  • Similar Content

    • By Jers
      I need to know what I have and what tire really go on it, Mine has 24x11x10 on the back and 22x8x10 on the front and I need new tire but I don't think are the right size. Also I can't find the model number listed but it looks like a 250 quadrunner 2wd and I think it is a 1987 maybe, can anyone help me, also I it has a rich running sound and I put a carb diap in it and cleaned the carb. is there a jet needing replaced?
    • By davidwestfall
      looking for direct shift shifting lever that properly fits my 2003 Yamaha warrior 350 and fits my foot the same as a stock 2003 Yamaha warrior 350 shifting lever fits my foot
    • By Wonderwoman
      Hello, well back to where I was last year with this carb. Took my 250 to the mountains for the first time this year and blue smoke, too much gas again. I can't believe that this carb gives me this much trouble. Seems like the choke is stuck but the cable moves freely. Anyone else ever experience this issue? Do you think a new choke cable would maybe resolve this?http://www.quadcrazy.com/atvforum/images/smilies/arghh.gif
      OK it was the choke. Put on all new cable and plunger and she is running 100% again. So now the question is, is the carb getting worn out where the plunger needle goes in the small hole and when I use the choke the needle end doesn't get lined back up with the hole?? We'll see how it runs and now that I know what the issue is I can always pull the choke plunger out and reinstall if I start having this issue again.
    • By Racer944
      Hi Folks;
      Has anybody on here installed a winch on a 2003 Magnum 2x4? I am using a Cycle Country adapter plate (only one I could find), but am having a bit of trouble getting it all to fit properly, and am looking for someone that may have done this install and/or may have some pics of the installation.
      Thanks!
      Eric
    • By evlsnke
      loud clicking, snapping noise under load when accelerating.
  • Recently Browsing   0 members

    No registered users viewing this page.