-
Popular Now
-
-
Similar Forum Topics
-
-
By Tjp5093
I'm working on my 02 Honda forman 400 and I have the side case off. I'm trying to see a picture of how the clutch fork and clutch arm on the end of the shifter shaft line up and what direction to face the triangle bearing with the spring.TIA!!!
-
By QuadConfussion
Hey everyone! Just introducing myself and hoping I can get some insight on where to start. I have an older quad, my guess is about an 07. I know it’s a 700 but I’m having some stalling issues with it after it runs for about ten minutes it will die out. It will start right back up and run but after a minute or two it will die again. Any suggestions on where to start checking things?
-
By Spartacus Stroppel
So I have a 2001 Kawasaki prairie 300 I could not find tough country snow plow... it's a older plow too boot... so I made the plow mount and updated the plow with some skids.
Mount plate is 1/4 steel plate and so are the pin points
The skids are off a moose plow. I got some plumbing black pipe for holders to weld to the blade and braced it with pieces left over from the plow mount 1/4 steel...
1/4 plate cost $45
Skids cost $24
U bolts and other hardware where $20
I got the blade free
-
By HeWasRidinDirty
Hey all. I got a stripped hub on this 450r ,and I ordered some new oem spec hubs, but they don't fit on the splines. I can't find and I.D or a name at all on the axle. The splines measure right around 28 mm. They're a good bit bigger than the stock ones. I even tried the hub from a 700 Raptor, but no-go.
-
COMMUNITY SECTIONS
ATV FORUMS
QUADCRAZY MEMBERSHIP
Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.