1995 Polaris Magnum 425 4x4 will not go into gear.

[Diabeticmoose]

I recently bought a Polaris 95' Magnum 425 4x4 and when i bought it went into gear with a good shove (Automatic ) anyways now it wont go into Hi,Lo, or R. I hear it click when i forcefully put it into gear but wont move. Also i wanna note that after a week of having it (never offroaded wit it yet only because the rear was loose and i had to replace bushing to keep it from shaking) That it went foward in Hi,LO, N, and R than just wouldnt go back into gear after that. Any ideas?

[Ajmboy]

When you are trying to get it into gear, if you rock the atv forward and back...does it slip on?

* Adjusted your title and included manufacturer.

[Ajmboy]

Any update on this?

[Rscheeler]

I had a similar issue where it would grind really bad when going into gear. I turned my idle down just a bit and actually also took off the belt cover and cleaned the clutch weights and clutch unit. It was pretty dirty. It works great now maybe u could have some luck

[garyross]

when it is in nuteral it runs fine but when i put it in gear it will die also if i start it in gear it will run for 4or 5 seconds and die.

[CK1999_400ex]

it also sounds like you might have an electrical issue ... check plugs an connections for corrosion