Quantcast
Jump to content


2002 Honda TRX400EX couple questions


Fogel

Recommended Posts

well i went and bought my first sport quad. a 2002 honda TRX400EX quad for 600 bucks. it needs a new bearing carrier, tail light, battery box,battery, airbox lid, muffler, chain and 1 more set of brake pads. this is it i just got it home.

my questions are,

1. on the rear end of all the 400ex's on the left hand side i see a cyclinder type deal on the sub frame what is that since mine doesnt have it?

2. when i put an after market exhaust on here do i need to rejet? since all these pipes ive been looking at so no need to rejet blah blah blah

3. on the airbox theres a 2nd tube running from the box to the top of the motor what does that do and do i need it? since theres no filter on it so i didnt figure it did anything.

390113_10150607386132729_586052728_11811362_1092491032_n.jpg

390113_10150607386132729_586052728_11811362_1092491032_n.jpg.176fa4313762f6fa4cdf08fb279a18eb.jpg

Link to comment
Share on other sites

the cylinder thing should be the stock tool container ...and yes you should rejet and the the tubes slould be the air intake tubes 1 should run up under the gas tank if i remember rite and the other i think is a vent that should go to the vent on the rear top of the motor case and there is a drain tube that is in the bottom of the air box that is to let and water out ...

Link to comment
Share on other sites

The other hose that comes from the top ofthe motor that goes into the airbox takes motor fumes and blowby and reburns them. There should be a check valve but not 100% sure

As CK said a rejet is a must. No room for error on an air cooled. 400ex come from the factory lean so any additional air flow needs added fuel. Without it pinging or burnt valves can occur.

Sent from my SGH-T959V using Tapatalk

Edited by marioweldinginc
Link to comment
Share on other sites

  • 2 weeks later...
well i went and bought my first sport quad. a 2002 honda TRX400EX quad for 600 bucks. it needs a new bearing carrier, tail light, battery box,battery, airbox lid, muffler, chain and 1 more set of brake pads. this is it i just got it home.

my questions are,

1. on the rear end of all the 400ex's on the left hand side i see a cyclinder type deal on the sub frame what is that since mine doesnt have it?

2. when i put an after market exhaust on here do i need to rejet? since all these pipes ive been looking at so no need to rejet blah blah blah

3. on the airbox theres a 2nd tube running from the box to the top of the motor what does that do and do i need it? since theres no filter on it so i didnt figure it did anything.

the round container you see is the fractory tool box the the tube you are talking about is a vent to releave the crank case pressure and recirulates the air back into the air intake boot alot of people will disconnect this and replce it with a small micro filter that can be bought at oreilys auto parts do not leave open drit and grimm will result in engine damage. it suggested to jet most carbs with after market pipes dealing with air/fuel and back pressure that is needed to make any motor to run.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By pitts
      Just joined so I can download a manual and In the process of making my 10 posts.
    • By Brantley11
      Hey everybody,
       
      My proficiency is with Hondas and Yamahas make me see RED!
       
      This bike is my brother in law's, it has 1199 miles on it and went from running great to dead with no start. Every once and a while it will start and sputter for 2 seconds. It is extremely sporadic when it fires but never runs for longer than 3 seconds. 
       
      Here is where we sit:
      Brand New Fully Charged battery
      Carb was cleaned with air hose and carb cleaner then into the ultrasonic cleaner with Aircraft aluminum cleaner
      New Shindy Carb kit (made in Japan version)
      Cleaned out petcock and gas tank
      New 93 Non Ethanol Gas
      New Spark Plug
       
      It gets a spark through the spark test light every time
      Bluish white spark
      When holding the spark plug 1/4" - 3/8" away from head it will jump and spark to the head
      Good Compression
       
      Here are the readings:
       
      Pickup Coil 519 Ohms (range 459-561)
      Charging Coil 266 Ohms (range 270-330)
      Lighting Coil 0.700 (range 0.702-0.858)
      Spark plug Cap 10.58 Ohms (10kohms
      Ignition Coil Primary Coil 0.5 ohms (range 0.18-0.28 ohms)
      Ignition Coil Secondary Coil 8.20 kOhms (range 6.32-9.48 kOhms)
       
      Would y'all think stator and pick up coil, rectifier or CDI are the culprit?
       
    • By newguy024
      Just got into ATV riding just last week, never had much money so i couldnt afford to buy anthing, so now at the age of 34 i just bought a 1987 suzuki quadrunner 300 for 500$ took it out a few times and what a rush of excitement to go through that first mudhole haha!
    • By NZrider
      My king quad 700 runs rough when cold then won't start some times but not often when it's hot. And occasionally smoke's a lot when it's cold I'm guessing that's rings but I'm worried unless it's causing the other problems
       
       
       
      All help is appreciated thanks
    • By jatho
      Has anyone else had an issue on older king quads where the oil would leak from the top of the head (due to a failed gasket) and drip onto the hot exhaust? Mine got so hot one time it caught fire. Just wondering if this is a common issue, as I've seen the same thing happen on multiple bikes that were the same model. 
×
×
  • Create New...