Quantcast
Jump to content

Recommended Posts

Posted

Just bought a 1995 300l 4x4 yesterday and it has been sitting for over 7 years. Have put a new battery in it but I am unsure other than draining the gas what to do before cranking it over. Was real lucky on this deal. I picked up the 300l and a 1999 Magnum 500. both for $450.00 Canadian. Both ran prior to leaving them sit and are were sold as no start parts quads.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By LMI
      Hi all.  New to the forum & quads.  Seems like a great place full of info.
      I just recently picked up a 2005 Suzuki KingQuad LTA700.  I need a battery.  I've been reading up on conventional vs AGM types.  I have a Royal Distributing and Canadian Tire.  RD has 2 types avail for my year/Model a battery YTX16-BS CRANK $75, and BATTERY YTX20CH-BS YUASA $140.  Neither of these is the type from the manual FTZ16-BS.
      from what I can tell... I think the only difference is the capacity with the $75 unit rated at 14 AH/10HR and the $140 unit rated at 18 AH/10HR ... which is the rating in the manual for the FTZ16-BS.  How much does this make a difference for nearly x2 the cost?
      And about the models/type numbers.... what is important to know ... they all end in "-BS" but are the other details relevant or just manufacturer naming?
    • By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.
    • By tds7
      The battery on my Big Bear drops completely down in the battery compartment nothing sticks up to grip too, plus there is only 1/8" clearance along the sides, no way to get a grip on it to pull up out of battery compartment. I thought about putting a piece nylon strap under the battery and leaving enough up each side to give me something to pull it up out ff the battery compartment or using a big zip tie around the battery.
      Any others have any ideas or have had this issue. 
       
    • By middlebrookgt
      I have replaced the cracked stator cover on my non-running 2006 LT-F400F that I purchased recently, checked all the shafts vs the service manual and pics and advice here.  I replaced missing gears, bushings and washers, made sure that truth marks were all aligned properly, that the shift cam springs felt like they returned properly, etc.  IAfter installing the new stator cover I checked the transfer lever for proper movement from L-H-R and then cranked it up.  Happily, it runs and changes gears well in L,  but it will not shift into H or R for anything.  I have opened it back up and am going back through it looking for the missing puzzle piece(s) but how can I best check that I have everything right this time before buttoning it back up?
    • By sunn
      Anyone with experience on relocating the miniscule battery from the front lower center wheel area to the left rear wheel area on the Polaris Sportsman 570?
×
×
  • Create New...