Quantcast
Jump to content

  • Do you own an ATV? Join our Forum!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.

1999 Polaris Magnum 500 Wiring Diagram

   (0 reviews)

1 Screenshot

About This File

Wiring diagram for 1999 Polaris 500Magnum




User Feedback

You may only provide a review once you have downloaded the file.

There are no reviews to display.

  • Similar Tagged Content

    • By flyinbrian365
      View File 2002 Polaris Magnum 325/500 Service Manual
      2002 Polaris Magnum 325/500 Full Service Manual
      Submitter flyinbrian365 Submitted 05/14/2020 Category Polaris ATV  
    • By flyinbrian365
      2002 Polaris Magnum 325/500 Full Service Manual
    • By Tyler Reed
      Came here for help, If it’s in the wrong place I’ll move. I’ve got a 2000 model Polaris Magnum 500 that runs strong as can be for about 25 mins until warm, then sputters and loses power. Took it to a shop and they say it’s low compression and they will have to swap the entire engine. Seems a bit much and costs more than the entire bike. Was wondering if anyone has seen this and what the fix was. When I hear compression I think of gaskets, not an entire engine. Seems like if it was that bad it wouldn’t have power cold. I’m at a loss. Any help is appreciated greatly. 
    • By Dan Ellsweig
      Greetings
      I have a 98 Polaris Magnum 425. Runs GREAT for 10 minutes then starts to load up (sounds rich) and looses power. Final;ly just stalls out on idle. If it sits 20 minutes will run again.

      replaced fuel, added fuel treatment (seafoam), Replaced plug (carbon fouled), plug wires, air and fuel filter, checked all fuel and vac hoses, REPLACED carb with new. Still no good. Just ordered a coil, not sure if that will help
      Note: both the new and old carb only had the idel adjuster screw - cant find the jet adjustments or air/fuel mix screws so I cannot say how they are set.

      Looking for ideas short of spending big $$ on Polaris service

      HELP?????

      Thanks

      Dan
    • By Joseph Miller
      Hi guys im new here and ive been doing alot of research on my polaris predator i was wondering if anyone on here has wired a different cdi up on there quad? Not a direct replacement that would simply just plug in. I know my white an w/red wires go to my pulsar my green an blue go to my reverse coil but im unsure which is + and which is ground also brown/w is a ground correct? What about purple? Black goes to my kill switch and red is my 12v supply........then ive got yelloww/red , yellow / yellow that goes to my rectifier..........any input on this subject is greatly appreciated thank you all
InstaFire Fire Starters



×
×
  • Create New...