Search the Community
Showing results for tags ' crack'.
Found 4 results
What's the best way to fix this?... Best idea so far is to clean it all up, sand the bottom side real good and find a piece of durable plastic I can shape and form to the bottom, and sand it as well. Then hold it all together somehow and epoxy the formed plastic to the bottom side. After curing, drill holes on both sides of the crack and thread wire through like shoelaces for support, pull tight and tie off. Seems like I read about some kind of goop you could use in this situation but I forget what it was called. I believe it would take the place of the epoxy. Right now I need advice on what kind of plastic to use and how to source it, as well as what kind of epoxy. I'm all ears.
So I have oil that comes out of out a small crack next to one of the top bolts. Anyone know a way to seal this or fix it without buying a whole new cylinder head? I was hoping there was something I could put on the crack to seal it or I know a welder that could just weld over it?? Thanks again, Keith
were would i have a leak at if my crack case oil is milky i have fushed it out and put bars stop leak in it and it dont look like milk no more but a brown color going to rise tomorrow and see if the bars stop leak works going to take extra oil to and change it out there to see how it looks but were would i have a leak at it on a lt250r could it be the water pump seal