Quantcast
Jump to content

Recommended Posts

Posted

Morning All,  Wondering if anyone has had any success using aftermarket carburetors on the smaller ATVs?  Picked up a couple Arctic Cat DVX90s over the weekend (2006 & 2008), and one of them has an aftermarket carb that needs to be replaced (it's missing the brass barb for the fuel line ).  Both are the same Kymco power plant, but different frame/body.

I swapped carburetors between the machines to test opreation.  Both ran great, and seem to manage the electronic choke properly. 

Am I better off to buy the replacement carb from AC ($250), or try an aftermarket?  Part of me wants a manual choke.....

Thanks in advance for any thoughts.

Posted

Aftermarket carbs are a much repeated topic here at Quadcrazy and will be a talked about topic forever! Many times here we’ve spoke about them and the general census is that they are not very good.  One of our memebers @JacobSlabach has mentioned that they needed to be adjusted way out from the spec position and has gotten them to work.   But the way I see it, if the quad is worth it then put an oem carb on. I always check eBay for a used oem.   

  • Like 2
Posted

I would agree with @Frank Angerano, Aftermarket just dont give the full performance that oem carbs do- but they will work.  I put them on bikes I plan to flip and so far, have had success with them.  If you are looking for a cheap fix, go aftermarket, but its kinda hit-or-miss with china.......no offense..tired over it GIF by Desus & Mero

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.



  • Popular Now

  • Similar Forum Topics

    • By BuckBilly
      Good morning to all !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
      Let's see if we can make this a daily event.
    • By noticon75
      Anyone ride at in the north east Kansas area? Tuttle Creek, Milford lake areas, Topeka?
    • By tepin
      Здравствуйте, нужна помощь по ремонту багги Arctic Cat 700 EFI, пропала искра, датчик коленвала импульс есть, Самодиагностика показывает две ошибки AC99,AC96. все провода проверил на целостность, все датчики блоком определяются, не включается топливный насос. Провода от ECU до реле насоса и от реле до насоса исправны. Поставил подменный ECU, ничего не изменилось.   

    • By Maxg_57
      Is anyone still active on this club
    • By Shorty51
      Good morning, I am new to the forum. I'm 75 years old and love getting ATVs back to usable condition. I particularly like the 2006-2009 Arctic Cat 250 Utility. I currently own 6. The 2006 I am working on only has reverse and low gear. The "drive shaft" in the transmission is completely stripped where the high gear would mesh. Has anyone on here replaced the shaft. I'm told I have to split the case. I was hoping that someone on here could let me know how hard it will be. I already have it stripped down to where the shaft coming in from the clutch side is the only thing left. I was hoping I could just remove the driven clutch and drive it out from there. Directions say different. Any help would be greatly appreciated.
×
×
  • Create New...