-
Popular Now
-
-
Similar Forum Topics
-
By Jdeaton011989
Hi all. I have a timberwolf 250 2nd that will not start.. I thought it was out of time bc the guy I got it from said it just quit on him. The tensioner had a nut welded to it and it was like2 teeth off. I installed new tensioner and chain and it still will not start. It has fire and it will not hit off brake cleaner. It has compression. Haven't put a gauge but I'm sure it will crank and run with what it has. I double checked my work and it's still in time. Spot on. Both valves move. I'm about to put a feeler gauge on them and I'll cone back but other than that any ideas?
-
By TomJulio
My 1992 TRX00 recently stopped firing. I understand this is a common problem. I have ordered an aftermarket CDI unit. TJ
-
By tflack500tbx
Background,
This winter (Dec.) I was plowing and everything just died, just quit. No lights, no pull start, No nothing. I've had this problem before and I changed the voltage reg and it ran fine for over a year. Then this. So I changed it again, thinking this was the same problem. Tried to start it and a small pin hole in the CDI appeared with electrical smoke.
Months go by and I finally decide to just replace parts (I'm Horrible at electrical issues). I changed the stator, new CDI, new Voltage reg, new starter solenoid, tested the starter (prefect), charged the battery.
Went to start it and the solenoid rapidly clicked. All the dash lights on, headlights work. Pull stared it and it fired right up no issues. Looked into the rapidly clicking starter solenoid and it was not enough juice in the battery. Took the battery completely out and hooked up a jump box to it turned the key, light on, everything looks good. Pushed the starter button and it fired right up ran great. Turned it off to test it again, Turned the key and nothing. No dash lights nothing. Took the jump box off and pulled started it. Started it right up. Re-hooked the jump box, still nothing.
Any Ideas?
-
By Guest
Hey all, new to the forum! I just bought a 1998 Kawasaki bayou 300, 4x4 not running. Initially I found no spark. Ended up playing with the plug wire (made sure plug top and wiring was touching) and got spark yesterday and the quad fired up off ether. Come to work on it today and now no spark again. Before I got spark and now today if I touch the plug after cranking I get shocked, and it will spark after I release the starter button. I was jumping the quad with a freshly charged car battery that has 12v while cranking. Cleaned out the kill switch and ignition button. All looks good. Purchased new plugs. They're are a lot of wires cut/ disconnected. But shouldn't matter if I got spark without them connected...
-
By Jason39
I’m having a issue with my choke when its on it runs fine when I cut the choke off the atv cuts off went to take the carburetor off and saw the choke plunger broke at the nut to screw it in could this be my issue? Do I just need to buy a plunger kit and put it on? I took the carburetor off and cleaned both jets anyway just to make sure and it’s still having issues staying on
-
COMMUNITY SECTIONS
ATV FORUMS
QUADCRAZY MEMBERSHIP
Be a part of best online community of ATV riders and join thousands of people who love ATVs! Share your ATV photos, videos, ATV rides, get help with your ATV and more. Not a member?
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.