Quantcast
Jump to content

Recommended Posts

Posted

i have a artic 400 that has been setting up for approx. a year or so. when i parked it, it ran fine and never had any serious problems until now. it has approx. 900 miles on it. i just recently pulled it out and began riding again. it has now began to smoke alot. just wondering if i need to go ahead and have the top rebuilt or any suggestions.

Posted

well it could be several problems from sitting.... i fuel can be bad .. but that wont cause it to smoke very much...,the seales on the valves can be cracked and worn ... the rings can be worn or stuck some what in the groves on the piston from sitting causeing the smoking... if the air filter is very dirty it can cause it to suck oil from the crank case an smoke also... i wouls check the easy things to fix first then go from there ...

Posted

How many miles have you ran it after you got it out of storage? I would do an oil change and as CK suggested drain and refil the fuel. 900 Miles is still young in its life for a rebuild unless it was under water or there was a crack in your intake boot.

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By docdoug72
      Has anyone had a suzuki 230 quad lock the engine up?  Its a well maintained bike, it locked up when my son was riding it. Pulled the plug, it has connected with the piston. I'm thinking the con rod let go.  I don't have a service manual.  Does the engine need to come out to check further?
    • By kawasig
      Hello All
      I'm kinda new to ATVs. I just bought a 1987 Suzuki quad runner 230 Dual Range. I'm having a problem finding info on it. It's very clean, only 2.800 miles. The front wheels are only 30 in.center to center. I was thinking about adding wheel spacers to give it more stability. I realize the added stress on ball joints and bearings. I'm wondering if there are any other concerns? Any input is greatly appreciated!
    • By Tim Keiper
      1st problem, Does anyone know where I can find a stock carb for my Timberwolf, I have tried two different aftermarket carbs and they both suck. The machine runs great until it gets good and warm, then it keeps stalling unless I feather the throttle. it will even stall while I'm trying to go from 1st to reverse or vise versa. I took it to a buddy of mine who is a bike mechanic for years, and he told me try to find a factory carb. When I look online from dealers it says "NOT AVAILABLE" anyone have any suggestions ?
       
      2nd, The small tab on the rear axle for towing is to short for even pulling my small yard trailer, I can't even turn a little bit and hit hits. I tried making an extension which worked great as far as length, but it bends the tab and then the extension drags the ground. I have an idea of what to do to fix it, but wanted to see if anyone else has had this problem and see how you solved it.
    • By BuckBilly
      I like to ride in wooded and grassy areas. It takes my mind off the everyday routines and helps me deal with my father's cancer. Also gives me a reason to get involved with forums like this one.
    • By Travis_Smith
      I have a 2002 Kawasaki Prairie KVF 400 and im trying to figure out the actual float height... i have read 17mm +- 2mm, seen 13mm and 23mm... what is happening is it will start right up, rev a little and all is fine, when it warms and you put a load on it bogs down and sputters. no i don't have a manual
×
×
  • Create New...