Quantcast
Jump to content


1986 Suzuki lt230 - Questions


flatline

Recommended Posts

ok my friend keeps his quad at my house since he lives in town all i have to do is keep it maintained. so the other day we were riding and noticed it was getting harder to shift. now stupid question, i know where you put the motor oil in and thats good to go but is there trany fluid or any thing like that? if not where would i start in figuring out why its hard to shift.

another thing is it wont idle right, tried adjusting the idle adjustment on it but just wont do it. think i need to get it apart and clean it up.

also is there any thing else i need to do to keep this thing up and running?

Edited by flatline
Link to comment
Share on other sites

ah ok thanks for the reply, i just changed the oil and put motor oil in her. guess its a trip to the store to get the right oil and rebuild kit for the carb.

on the fill tube for the oil it just says 10w40 so i thought it would of been reg. oil. now i know better.

Link to comment
Share on other sites

your motor oil acts as the transmission fluid. make sure it is atv oil and not car oil. the atv oil has the additives for the clutch. sounds like the carb needs a really good clean and maybe a rebuild kit - it will include the rubbers, gasket and jets ...

Yes. Very good points. I use Valvoline ATV oil from the auto parts store. It has the additives.

Sent from my iPhone using Tapatalk 2

Link to comment
Share on other sites

  • 5 years later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By JohnnyB
      Greetings, 
      Have a 88 LT80 that been sitting for a couple years. Bought a new piston, cylinder and head. Installed these, rolled it over and it quickly locks up.  Took carb apart. It was full of what appears to be 2 cycle oil. Cleaned it, but keeps locking up and 2 cycle oil continues to seap from exhaust port.  When i installed new cylinder, I noticed crankcase was full of oil.  I'm now wondering if that oil is what's getting sucked up into cylinder.  Should there be no oil in crankcase?  If that the case, how is crank and rod lubricated?  Sorry, never worked on a 2 stroke. Thanks!
    • By Mhatayas
      What should I do about this , bad oil leak where the filter cover bolts on . Can I use some gasket maker 

    • By mga
      I see quite a few ads for that  Tribotex additive. It's kind of expensive, has anyone used it it their ATV or any other vehicle?
    • By HSTAR
      Hey I have a 1997 big bear 350 4x4
      I replaced the shifter shaft and the shift arm linkage and the rod when I installed them all I was unaware that you had to line the dot on the shifter shaft with the gap on the linkage arm gap put it all back  together and rode it I can't get it to shift in the right gears  I can move the shift cam by hand and goes in different gears but with the shifter shaft in it riding I can't put it in R or N 
      Anyone know how to line up the shifter shaft and the shift cam s
       
    • By NZrider
      My king quad 700 runs rough when cold then won't start some times but not often when it's hot. And occasionally smoke's a lot when it's cold I'm guessing that's rings but I'm worried unless it's causing the other problems
       
       
       
      All help is appreciated thanks
×
×
  • Create New...