Quantcast
Jump to content

Recommended Posts

Posted

:huh:I left my Cat sit for several months while I visited the "States" for summer in WI. battery had been removed. When I got back here to Panama and on the road again, I occasioned to find that the winch was non-responsive. Now, we have quite a bit of humidity here during the rainy season (it was doubly covered with tarps) and I'm guessing corrosion of contacts or wires.

I've cleaned all the connections, except the rocker switch and solenoid are sealed. No luck. Shouldn't I be able to run 12v directly to either the large diameter blue or yellow wire on the winch and see if the winch itself works? I got spark, but no function.

2nd question: I have an 8 post solenoid and I know the part # is 0409-066 and it is a Warn winch made for Arctic cat, but, I cannot find a model number on the winch so I can look up a wiring diagram. Can anyone possibly tell me which model winch I likely have? 2005 500LE automatic Arctic Cat. Or which winches use the 8 post solenoid? I have not been able to find any diagram of Warn winches that use an 8 post solenoid (lots of winch diagrams are available).:skeptic:

Posted (edited)

Just a safety sticker on the end, a sticker on top saying "Warn, made for Arctic Cat". I'll have to remove the winch. I'll get back to you.

Well, before I got that far, I decided to jump 12v to the winch posts. Now, my battery is apparently dead and won't take a charge. I don't see how a perfectly good battery could have been effected. The pull start works, but even after running for 20 minutes I can't even blow my horn very well and the lcd display gets all scrambled when pulling on the hand brake lever or blowing the horn, etc.

So it's either not holding a charge or the charging system isn't working.

I will get the battery tested and see.

Edited by data89
subsequent event

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By LMI
      Hi all.  New to the forum & quads.  Seems like a great place full of info.
      I just recently picked up a 2005 Suzuki KingQuad LTA700.  I need a battery.  I've been reading up on conventional vs AGM types.  I have a Royal Distributing and Canadian Tire.  RD has 2 types avail for my year/Model a battery YTX16-BS CRANK $75, and BATTERY YTX20CH-BS YUASA $140.  Neither of these is the type from the manual FTZ16-BS.
      from what I can tell... I think the only difference is the capacity with the $75 unit rated at 14 AH/10HR and the $140 unit rated at 18 AH/10HR ... which is the rating in the manual for the FTZ16-BS.  How much does this make a difference for nearly x2 the cost?
      And about the models/type numbers.... what is important to know ... they all end in "-BS" but are the other details relevant or just manufacturer naming?
    • By HoldenBoy
      Hi all,
      Looking for some help on a starter/bendix issue. Can Am outlander 450 2017. While cranking to start, the starter spins and engages into the ring gear. After a few seconds the bendix retracts while still spinning and there is no damaged teeth on the drive pulley.
    • By tds7
      The battery on my Big Bear drops completely down in the battery compartment nothing sticks up to grip too, plus there is only 1/8" clearance along the sides, no way to get a grip on it to pull up out of battery compartment. I thought about putting a piece nylon strap under the battery and leaving enough up each side to give me something to pull it up out ff the battery compartment or using a big zip tie around the battery.
      Any others have any ideas or have had this issue. 
       
    • By Tim Keiper
      I have a Yamaha Timberwolf 4x4 250. I want to put a winch on it, but just wondering if the charging system will handle it or not ? Has anyone added one to their machine and have you had any issues?
    • By sunn
      Anyone with experience on relocating the miniscule battery from the front lower center wheel area to the left rear wheel area on the Polaris Sportsman 570?
×
×
  • Create New...