Quantcast
Jump to content

1998 Honda Four Trax 300 2WD


capteddie

Recommended Posts

Just pick this up today, every thing working and runs great. My question is the rear end. I checked the oil level and found none. What I did see looks like dried grease. How do I clean this and what do I put into the rear end, grease or oil?

Can some one tell me where is the oil filter on my TRX300?

Also looking for service manual for my model.

Link to comment
Share on other sites

My 1995 300 2wd used 30 weight motor oil and I believe it was 3 or 4 ounces. I would just add the oil and run it some and drain and refill.

The oil filter on my 95 was above the oil fill hole. Take the plastic cover off and then see the 3 triangular bolts that hold the housing cap on.

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Mhatayas
      What should I do about this , bad oil leak where the filter cover bolts on . Can I use some gasket maker 

    • By BruceG
      Hi guys. I have a problem where the quad will start and run well for about 5 minutes and then it dies. On inspection the airbox has oil in it (quite a lot). The oil is pumping through the cylinder head breather hose. This problem first happened suddenly. I have since done the top end including, piston, gaskets, rings and valves. I have also done the carb (not that I thought that this was the problem). The compression seems normal. The only thing that I can think of, is that I did not grind the valves well enough. Anyone experienced this? If so, how did you fix it? Any other thoughts?
    • By hardcastle
      My friends KQ 300 starts fine and runs, as soon as you put it in gear and try to accelerate its bucks and farts like crazy, not moving... I cleaned carb and it worked good for 1 day... now back to same problem.... could it be such as a bent valve????
    • By Lafytafy
      should i run a thicker oil in a older quad because it make a little more noise than usual 
    • By Clydaho
      2022 Sector 550, 414 miles on it and the gas gauge reads empty.  I topped off the gas and it didn't change.
      There is no fuse that I could find.  No access at the gauge cluster.
      Wiring on the top of the tank looks good, properly connected.
      Could the sending unit in the tank be stuck or broken?
      Has anybody removed the tank lid?  Any tricks?  
      Any other ideas?
      Thanks for any help,
      Clyde
×
×
  • Create New...