-
QUADCRAZY ATV Forum & Community
Welcome to QUADCRAZY, an online ATV Forum & Community. Connect with fellow ATV and UTV enthusiasts on our active forum dedicated to all things off-roading. Share tips, tricks, and stories, and get advice from experienced riders. Find ATV and UTV owners and enthusiasts ranging across all makes including Suzuki, Yamaha, Polaris, Arctic Cat, Kawasaki, and Honda. Join today!
Other Region ATV & Off Road Forum
Includes Puerto Rico and other US territories that are not part of any census region or census division. Also includes other countries and regions around the world.
14 topics in this forum
-
- 1 reply
- 2.8k views
-
- 10 replies
- 12.8k views
-
- 0 replies
- 995 views
-
- 2 replies
- 3k views
-
- 5 replies
- 3.5k views
-
- 11 replies
- 6.9k views
-
- 0 replies
- 891 views
-
- 6 replies
- 4.3k views
-
- 1 reply
- 1.3k views
-
- 1 reply
- 1.5k views
-
- 1 reply
- 2.5k views
-
- 1 reply
- 4k views
-
- 0 replies
- 2.1k views
-
- 1 reply
- 3.5k views
-
Tell a friend
-
Recent Forum Topics
-
4
2009 Ttr 125le rear shock trouble
I'll grab one tomorrow that's what I was thinking it shouldn't affect the hight of the spring just the stiffness -
4
2009 Ttr 125le rear shock trouble
Well if it went in the other day it should go in again.. I'm not familiar with that bike but most shocks you can adjust in place. Mostly when we adjust the spring tension of a shock it doesn't change the length of the shock. The shock is usually fully extended by the spring and adjusting the spring makes no difference to that unfitted length, it only adjusts how far the bike drops once the weight comes on it. If you lift the bike the shock should fit no matter how the spring's adjusted. Perhaps if you can post a photo of the setup on that bike I'll spot a problem. -
2
1992 kawasaki bayou 300 KLF300-B5 repairs
There should be a short brass tube on the bottom of the carb for a rubber hose I'd think. The leak.. There's a drain screw on the bottom of the carb I think, and that might be leaking. Other than that it shouldn't leak unless the fuel level inside the carb is too high. I think you can check the fuel level before removing the carb. To adjust the fuel level, or fix the leaking float level valve, you will be best to remove the carb and clean it and check the rubber parts aren't worn or perished. You might be able to remove the bottom of the carb in place but it's best to take the carb right off, strip it entirely, clean and inspect it all and then reassemble it and it should be right for years. -
19
1990 YFM350 VIN JY43HPW05L00xxxxx
I'm not familiar enough with yamahas to be much help here, but I would definitely say repair the old wiring rather than trying to jury rig some other model wiring in there. To figure what the cut wires are for I'd look at what's near by on the frame or engine, and then go check a or several wiring diagrams looking for those coloured wires being shown connected to one of those things I'd identified near the wires. I'd also keep referring back to partzilla to see what other model wiring diagrams I should be looking at. When I looked a few parts up it seemed that your bike shares parts with wolverine, moto4, BB and kodiak, and over a range of years.. To identify exactly what components you have on your bike is going to take a lot of familiarising yourself with the bike and looking through partzilla, and even then It might be tricky to know the exact details about electronic parts. The shape, colour and pin locations of plugs, and wire colours, are clues when looking at wiring diagrams and identifying parts. -
4
2009 Ttr 125le rear shock trouble
It seems like the rear end of the bike won't drop down far enough -
4
2009 Ttr 125le rear shock trouble
You mean the length seems wrong now ? Have you tried lifting or lowering the bike so the shock mounts line up ? -
19
1990 YFM350 VIN JY43HPW05L00xxxxx
The only yamaha i have to show photos of is a Big Bear and its 10 years newer than yours but may show where the starting componets hook up. T The battery and soloenoid and relaus sit on top of the plastic on this one, yours will be different but around your battery tray there should be brackets or something similar to hold the components. Black coming from starter to soloenid, red to battery, Plug in with blue, blue /white and red going to start switch 2 black boxes are relays. The other is fan controller. Behind aall that is the air box which i didnt see on your photos, mine was missing also. -
4
2009 Ttr 125le rear shock trouble
So I installed a new shock on my 125 yesterday sadly it wasn't adjusted right I took it off to adjust it tried to install it again today and it no longer fits I loosened the nuts on the spring again and it still won't fit idk what I'm doing wrong when I try to install it but I'm lost any tips or videos would be great thanks. -
19
1990 YFM350 VIN JY43HPW05L00xxxxx
@GwbarmIf I can get a member who has a 1989-90, to tell me what goes into the 3-pin and the 4-pin connector, just under the left side of the tank, then I can fix up the rest well enough to do as you say, the engine etc. It feels and looks solid. Just janky electric is my guess at this point. -
19
1990 YFM350 VIN JY43HPW05L00xxxxx
I think the first thing i would do is evaluate the engine and transmission, make sure the engine has good compression. Then jack up the rear wheels where you can turn them by hand and make sure it shifts though the gears correctly. Of course they can be fixed also but i like to start with engine and transmission then see if it will run.- 1
-
-
