Quantcast
Jump to content

Recommended Posts

Posted

I bought a 2008 arctic at 366 with 120hrs. When i red line it in neutral is smokes blue a lot. When I put it in high range it has problems getting over 35km/h. I bought it and had to clean the carb. It ran ok after i cleaned it. Not I have this problem. 

Posted

air rulers fine. I cleaned the carb again and just before the carb there is an air box. The box was FULL OF DIRT. I cleaned it out and it runs great but still smokes blue. I'm thinking sand or dirt got into the cylinder and scored the cylinder walls. 

Posted

Ok so I definitely need to redo my rings because today I started it up and it smokes really bad. Does anyone have a price on how much this costs if I do the rings myself?

  • 1 year later...
  • 7 years later...
Posted

I suspect it probably would not fit , the 366 is a Kymco engine and the 400 is a Suzuki engine. Even though the engine specs are close to the same i think the chances of a Suzuki top end fitting a Kymco engine to very very slim. Could be wrong, never tried it.

Posted
19 hours ago, Gwbarm said:

I suspect it probably would not fit , the 366 is a Kymco engine and the 400 is a Suzuki engine. Even though the engine specs are close to the same i think the chances of a Suzuki top end fitting a Kymco engine to very very slim. Could be wrong, never tried it.

Correct, the 400 is Suzuki, the 366 is Kymco.  I had a 2010 366 that my girl rode, Sold it this summer after buying another machine. It had 11,000 miles on it and still ran well.

Her current machine is a 2017 400 Alterra, which is basically the same machine as the 366 with different plastics.

 

  • Like 1
Posted
15 hours ago, jen said:

The 400 altera i a Kymco motor?   Taiwanese.

The 366 model (2008-2012?) and the Alterra 400 (2013-2018) were Kymco motors.  I don't know if the newer 400 model is, they changed it now to the 425 which I think is the re-designed model which would be Arctic Cat / Trakker motor.  Some of the parts on her Alterra say "Kymco" on it. 

My 450 is an Arctic Cat motor, my new 600 is the re-designed machine (trakker motor) 

Kymco is a good brand, in fact Michelle's FIRST quad was a Kymco (2008) it was OK, but being a sport model, she got beat up on it since our local terrain is rocky. In 2010 I got her the black Arctic Cat 366 model which was much better. Sold the Kymco and to this date, it is still running. 

100_1739 (Medium).JPG

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By Cj Winds
      I have a 2009 Honda Rancher TRX420FA with shifting problems.
      Usually it shifts ok when cold but after couple minutes it will stop shifting with no codes.
      The 1st shift clutch oil pressure when in first gear is 74psi. The 2nd shift clutch oil pressure when in second gear is 74psi.
      The 1st shift clutch oil pressure when in neutral is zero. The problem is when the tranny is in neutral the 2nd shift clutch pressure starts around 10-15psi and builds to 20psi. Is this normal?
    • By OldATVowner
      Just getting into this issue really. Been replacing solenoids but now I'd like to track down the problem. This time I'm not getting neutral/reverse lights or start button. Was on a creek ride when it started doing this recently. It cranks by arcing the solenoid and gives me no light or start button but if I crank with the pull cord....the neutral light and the button work. Turn it off and try to crank with the key and nothing. I'm looking into the safety switch issue tomorrow and re charging the battery. Just figured this was odd enough of a problem that you guys might be familiar. Thanks
    • By tepin
      Здравствуйте, нужна помощь по ремонту багги Arctic Cat 700 EFI, пропала искра, датчик коленвала импульс есть, Самодиагностика показывает две ошибки AC99,AC96. все провода проверил на целостность, все датчики блоком определяются, не включается топливный насос. Провода от ECU до реле насоса и от реле до насоса исправны. Поставил подменный ECU, ничего не изменилось.   

    • By Shorty51
      Good morning, I am new to the forum. I'm 75 years old and love getting ATVs back to usable condition. I particularly like the 2006-2009 Arctic Cat 250 Utility. I currently own 6. The 2006 I am working on only has reverse and low gear. The "drive shaft" in the transmission is completely stripped where the high gear would mesh. Has anyone on here replaced the shaft. I'm told I have to split the case. I was hoping that someone on here could let me know how hard it will be. I already have it stripped down to where the shaft coming in from the clutch side is the only thing left. I was hoping I could just remove the driven clutch and drive it out from there. Directions say different. Any help would be greatly appreciated.
    • By wilmpie
      hi everybody
       
      I have a kymco mxu 250 automatic from 2006 250 cc  that keeps going forwards or backwards when i shift backwards or forwards an then shift to neutral .
      if i shutdown the motor and push the quad and restart then its in neutral and don't go forwards or backwards, i already checkt if my motor is running good stationairy .
       
      what can it be or what can i do to fix this?
      thanx in advance
      p.s. Sorry for my bad english it's not my first language.
       
       
       
×
×
  • Create New...