New in California
-
Similar Forum Topics
-
By spock58
Hard working Grizzly with lots of issues, barely made it off the trailer (and only in reverse)!
-
By DaveswMN
Pulled my '86 Moto4 out of shed where it sat for 20 years. I knew it smoked. checked it over a little put in gas and it fired right up!!
Drove about 100 yards, ran about half throttle wouldn't idle. Put on somenew parts, jug/piston and rings, carb and valve seals.
'went together ok, tuned it over by hand about 6 revs whick went well. Hit the starter it fired for about 6 revs and quit. tried it again fired once and then th sound of something slipping like maybe chain slipping over spoket.
Took cover off to watch cam sproket, hit starter again, heard same noise and the cam sproket was not turning but jumping a bit. Chain was still tight. You will probably tell me I need to split the lower case but hoping there mightbe something else.
I don't fully understand the chain tightener, the plunger only moves about 1/4 inch, should it move much more than that when off the motor and compressing it by hand?
Thanks for any thoughts.
-
By rafal
Hello,
My name is Rafal and I'm 43 and I'm from Poland.
I will go straight - I'll be glad if someone could send me service manual for KVF300 2001.
Its very hard to get it from the network.
Thanks in advance.
-
By motomutts
Check out this awesome event put on by www.utvoffroadadventures.com .. They have 11 UTV Events planned for 2022 so make sure to go to their website and check them out...
-

Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.