Quantcast
Jump to content

Recommended Posts

Posted

ya, i dont use it unless i need to and when i lock in i come to a complete stop, however sometimes a little feather of the throtle is needed in foward or reverse.. usually i here a pop or a snap when it comes out.

Posted (edited)

wen the axle pops out does it pop out completely? or just slides out of the diff a little? is their anything else noticeable like oil coming out of the differential? might be something off with the axle u check all the teeth make sure their all good...

Edited by outlander560
Posted

it slides out about 1/2 to 3/4 inches enough to dump fluid out. all the teeth look fine on the axle and on the locker ring gear and the axle does not apear to be bent, but i will be taking off and inspecting again.

Posted

hey i figured it out its the upper bearing, the inner race spun inside the outer about 0.050 causing the ball bearings to expand not enough to sieze in the cup but enough to eliminate almost all clearance for movement. the a arm drops axle comes out. i went out today and had a great ride and then totaly bend one of my rear axles, good times and good rides.

  • 3 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By TomJulio
      Looking for two stock front wheels for 92 TRX300 2WD.   I think they are 6 x11" size.     
    • By ButchM
      Hisun 700 EFI. Replaced TMAP sensor had broken off . Fuel pump pressure 41psi. The only way I can keep it running (and runs fine) is to close off fuel return line. 
    • By TomJulio
      I recently noticed my Fourtrax 2WD has 4WD wheels installed on the front.  The back spacing is significantly different than 2WD wheels and they are almost touching the strut springs and the tires actually do touch the springs..   So far, no luck locating 2WD wheels to correct this issue. 
    • By Olchap
      Hi, I am new to this forum I am currently working on my 1989 Yamaha front end.  The cv axles were bad so I changed them on both sides with all new wheel bearings. Now I'm looking at the front brakes and the 2 cylinders for the brake shoes on both sides do not work at all. I am also new at working on brakes so its a mystery to me what needs to be done to fix the cylinders.  Can somebody please help me with these brake issues? See the image below.
      Thank you,
      Olchap

    • By dkgg5755
      This thing came with a cheap aftermarket carb on it the problem I'm having is it won't start with choke installed into carburetor it will start and get run without it installed then bogs out after about 2 min run time I've checked timing , compression, checked valves for proper clearance , also did a smoke test for air leaks found none. 
×
×
  • Create New...