-
ATV Forum Leaderboard & Trending ATV Discussions
Welcome to the QUADCRAZY ATV community leaderboard featuring the most active ATV forum members, trending ATV discussions, popular repair topics, and top-rated ATV content from across the community.
Explore ATV troubleshooting, maintenance tips, Polaris repair discussions, Honda ATV topics, Can-Am forums, Yamaha ATV discussions, ATV accessories, mud riding setups, trail riding advice, and more from fellow riders.
🔥 Trending ATV Discussions
🛠 Popular ATV Topics & Tags
Browse popular ATV discussions covering ATV winches, mud tires, snow plows, batteries, helmets, maintenance, oil changes, repairs, upgrades, and trail riding setups from riders across the QUADCRAZY community.
🏁 Popular ATV Forum Categories
About the QUADCRAZY ATV Community
QUADCRAZY is one of the largest ATV forums online featuring ATV repair help, trail riding discussions, ATV modifications, buying advice, maintenance tutorials, and off-road community discussions covering Polaris, Honda, Yamaha, Suzuki, Kawasaki, Arctic Cat, Can-Am, and more.
Leaderboard
Popular Content
Showing content with the highest reputation on 09/13/2025 in all areas
-
Leaves are turning...I like to hunt squirrels after the leaves have fallen...I can see the little B---t--ds easier. But I love my old blot action 23 inch barrel Winchester. However, I have a Ruger 10/22/22 SS...This model has 22 inch barrel. I don't need to move to work the action after the first shot and give away my position for a second shot on another squirrel. Sometimes I will shoot in there chest so I can save the head as I like to eat the brains.1 point
-
Yes control transformers *MAY* work both ways but you have to look at the KVA rating of the transformer. (Small ones will rate by VA) The available current output would be less then 1/4 of the input current. Normally control transformers are designed for step-down only. Running them reverse would cause a lot of heating on the secondary side (being used as primary) since they are not designed for it (wire gauge is too small) If you really wanted to do that, they make step-up transformers for that purpose.1 point
-
I would clean the carb good with ultrasonic cleaner take the emulsion tube out also, hard to start hot sounds like low compression or flooding it might be just stuck rings that may come free after running a bit, i would check the compression with throttle open if low put in a little oil and check again if it goes up its rings.1 point
-
It sounds like the clutch is not grabbing what does it do when you give it more throttle make noise or just sit there or go slowly. Its also possible it jumping out of gear, try shifting again and see if it wants to move.1 point
