Search the Community
Showing results for tags ' setting'.
-
I have a 1996 King Quad 300 LT-F4WDX ATV I tried to install a carburetor rebuild kit but there were no instructions and I am unable to find them. Anybody know what the "Pilot Screw" is set at? The engine starts but seems to be flooding- very difficult to get the rpms up and engine acts flooded. I set the screw to 3 turns from closed. It is called the "Pilot Screw" on exploded views of the carb. It is a Mikuni BST 31 single carb. Thanks for any help! Bill Roberts
- 4 replies
-
- air
- carburetor
-
(and 2 more)
Tagged with:
-
When I push down on the rear brake pedal, it makes the left hand brake very sloppy. Is there a way to adjust that? I have a 2007 Suzuki Vinson
-
I have a timberwolf that I love. It sat and the carb got gel from this wonderful ethanol. I cleaned it and put a new kit in it. it always started right off. now it cranks forever before it hits and then it will not idle. set according to instructions 23mm float, 4th notch on the pin, 1 1/2 turns out on the AIS. I have tried tweeking all of these some but nothing seems to make a difference. The biggest problem is that I got it back out because the wife has claimed this bike and now it will not run for her. Any help would sure get me out of a bind.
-
i have a proplem with the idel i just got it from a friend who has't ran it in a long time so i changed the spark plugs and clean the carbs now it starts but idel real high ad the idel revs up and down so i mess with the idel screws and got it set but when i press the gas it shuts off does anyone know how to set them
-
Iam needing to know the measurement on float height on my 1991 suzuki lt 230 e and was wondering if anyone could help me out.Height and where to measure from and to. The floats themselves are round and seem to have no good centerline casting marking ect. Do i measure to top of float when holding upsidedown say at a 90 degree angel???? Any help is appreciated.
-
Hi all, I have a 2007 king quad 450 with starting/idle/power problems. My two boys had a go at it while I was away at work and now I found that the idle air screw was removed and I don't know about setting it up. I want to set this before I start on the other problems. New fuel pump, new injector, new foam air filter, error code reads -C00. Any help would be appreciated.
-
just put new valves in my 86 bayou 300 having a hard time setting the timing need some help or pics on the way to set up need help
-
what are the carb settings for an 04 beartracker
-
Hello all.....Brand new to the site......Been fun reading other peoples problems My problem is I am installing a new Head/Cam/Cover on a 99 TRXFW. Before you ask I do have a manual......The book states "line up the "T" mark and adjust.......Make sure you are on the compression stroke"........If the cam has been removed how can you tell if you are on the compression stroke and not on the exhaust stroke? My worry is I will install everything and it will be 180 out.....Can anyone help me?