Quantcast
Jump to content

Recommended Posts

Posted

2005 750 Kawasaki Brute Force...oil started sptting out near my airbox. I've never had problems with my Brute Force until today. It is running fine. After the oil began to spit out, I let it cool and checked the oil level which was fine. Looks like it's coming out of a hose that goes from my crankcase to the airbox.....any suggestions ???

Posted

Do you ride wheelies alot? If so the is the reason when you get those motors on an angle the oil will start to go up the crankcase hose on its on and as you continue on and you give it more gas as you know the airbox is sucking air from the get go so it makes it that much easier to get to suck it into the airbox. Hope this helps.... oh also you can take the hose extend it to the handle bars and go to autozone and buy a $5 filter and put it on the end and elimanate the problem over all.

Posted
2005 750 Kawasaki Brute Force...oil started sptting out near my airbox. I've never had problems with my Brute Force until today. It is running fine. After the oil began to spit out, I let it cool and checked the oil level which was fine. Looks like it's coming out of a hose that goes from my crankcase to the airbox.....any suggestions ???

This is usually the result of overfilling it with oil just like Stoopidbot1 suggested.

Did you check the oil when it had been sitting cold or after it had run for awhile?

Posted

Thanks for comments...I did check the oil before this happened and it was actually a little below the full line. After the incident, I waited until it cooled and it checked about the same.

Also, I was riding wheelies on it a few hours before the oil spit out...but when it happened I had driven about 3 miles at 25mph on flat surfaces.

Posted
Thanks for comments...I did check the oil before this happened and it was actually a little below the full line. After the incident, I waited until it cooled and it checked about the same.

Also, I was riding wheelies on it a few hours before the oil spit out...but when it happened I had driven about 3 miles at 25mph on flat surfaces.

i dont think that would make a difference

  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By prdicon
      I was looking to buy a new ATV. 
      I was debating between Polaris sportsman 450 and Honda rancher.
      Polaris it a bit cheaper.
      But can you tell me which one will have more demand on the used market? Which one will keep it's value better?
       
      Let's say 3-5 years from now.
    • By marlon smith
      1990 kawasaki bayou 300c idles fine but pops out exhaust and intake when trying to excel, will not take throttle past 1/4 , any one had this problem?
      have replaced carb twice, same thing, fresh built engine cylinder head, same as before, new spark plug, flywheel key is good, pulser test good, good spark
    • By dkgg5755
      This thing came with a cheap aftermarket carb on it the problem I'm having is it won't start with choke installed into carburetor it will start and get run without it installed then bogs out after about 2 min run time I've checked timing , compression, checked valves for proper clearance , also did a smoke test for air leaks found none. 
    • Guest
      By Guest
      Hey all, new to the forum! I just bought a 1998 Kawasaki bayou 300, 4x4 not running. Initially I found no spark. Ended up playing with the plug wire (made sure plug top and wiring was touching) and got spark yesterday and the quad fired up off ether. Come to work on it today and now no spark again. Before I got spark and now today if I touch the plug after cranking I get shocked, and it will spark after I release the starter button. I was jumping the quad with a freshly charged car battery that has 12v while cranking. Cleaned out the kill switch and ignition button. All looks good. Purchased new plugs. They're are a lot of wires cut/ disconnected. But shouldn't matter if I got spark without them connected... 
    • By Jason39
      I’m having a issue with my choke when its on it runs fine when I cut the choke off the atv cuts off went to take the carburetor off and saw the choke plunger broke at the nut to screw it in could this be my issue? Do I just need to buy a plunger kit and put it on? I took the carburetor off and cleaned both jets anyway just to make sure and it’s still having issues staying on
         
×
×
  • Create New...