Quantcast
Jump to content

Recommended Posts

Posted

whats up guys, need a little help here, the battery in my 96 honda fourtraxx 300 keeps draining. I disconnected the battery kickstarted it and tested power generated at battery terminals with motor only and was gettting 3.5 volts dc at idle and the quad ran fine with lights.

I then hooked battery up and checked started cylinoid for continuity with key on and off and had continuity both times, I also was able to start my quad by shorting terminals on starter cylinoid with key on and off as well.

I checked wires, connections and 2 fuses by battery and all checked out of, I assume its the starter cylinoide or is their things to check before buying parts--- thanks for your help

Posted

out of curiousity, are you suppose to be able to start the quad up by crossing the terminals on starter cylinoid even with the ignition in the off position, because mine starts starts up even with out the key in it

Posted

No, I don't think you should be able to start it without the key on. The key switch or the wires that run in/out of it are probably the issue. I would start by inspecting the wires for a dead short. If the wires look ok, then the problem is probably in the switch itself. Sounds like it is on even in the off position. I would take it apart and inpect it before replacing it. You may be able to fix it by cleaning it, could be some kind of metallic debris in the switch causing it to short.

Posted

I agree with DD. also check the wires at the switch for the 3.5 volts- there should be at least one hot there when OFF. that means the switch is likely screwed up. by the way, 3.5 volts is not enough to keep a 12 volt battery charged! Sounds like someone chased the problem around and then gave up on it. Could be a charging coil too. It's time to buy a manual with a wiring diagram in it. ebay city.... Keep at it, you'll find it.

PS: if you short across the starter terminals it should turn the starter over, but not start without the ignition switch set to run.

Posted

Hey man

i think you mean you were able to cranck your engine with the key on or off

that bike only works with conecting power, not grounding the cdi

you mention getting only 3.5 volts when engine running, no battery conected

your voltage regulator may be faulty

but to be sure, conect battery, check voltage on battery before you even turn the key on

now turn lights off and any other accesories you have off (have you??)

turn key on and kickstartit, when runing, check the battery voltage again, if its lower you have a battery voltage winner

just in case, disconect the three prung conector on the left side under the plastic corner that attaches to the gas tank, the one with 3 yellow wires, from the generator (stator), check continuity between them, it should be zero, also check each wire to ground, should be infinity, in this case voltage regulator is a winner

before u spend big bucks on regulator ask a friend whith same bike to trade regulators just to test, no harm will be done, no matter wich regulator you conect on what bike, i think all year models are the same, may be different on 92 or 95 models, but if conectors the same and wire color equal, no problemo, then make the same test on battery voltage, key off, then bike running, voltage should be allways higher

if your regulator proves good, then im affraid you need a new stator, i had that head exploding problem a few years back, when the stator checked ok and the regulator also, but by pulling the stator out, there was visible burns on one coil, so i had to re-wireit , too bad you are too far, i could rewire that stator myself for you

sorry for misspelling, keyboard has mind of itself

good luck

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Popular Now

  • Similar Forum Topics

    • By Cj Winds
      I have a 2009 Honda Rancher TRX420FA with shifting problems.
      Usually it shifts ok when cold but after couple minutes it will stop shifting with no codes.
      The 1st shift clutch oil pressure when in first gear is 74psi. The 2nd shift clutch oil pressure when in second gear is 74psi.
      The 1st shift clutch oil pressure when in neutral is zero. The problem is when the tranny is in neutral the 2nd shift clutch pressure starts around 10-15psi and builds to 20psi. Is this normal?
    • By Mikey509
      Hey guys, so I've been messing with my quad, and between all the starts, the battery is dead. Is there a certain way to charge these? Can I just throw a trickle charger on it and call it a day? can i also jump it like a normal car with a battery pack or is that to much voltage 
    • By Mikey509
      Hey guys i recently got a old recon 250 up and going and the prev owners had the carb screws all messed up. i was wondering if anyone can give me the basic run downs on if i turn both screws all the way "tightened" how many turns out will the quad run okay so i can then dial it in. the prev owner had the screws messed up so bad it woudnt idle. i got it to idle but idles rough. its super lean any guidence is appreciated 
    • By LMI
      Hi all.  New to the forum & quads.  Seems like a great place full of info.
      I just recently picked up a 2005 Suzuki KingQuad LTA700.  I need a battery.  I've been reading up on conventional vs AGM types.  I have a Royal Distributing and Canadian Tire.  RD has 2 types avail for my year/Model a battery YTX16-BS CRANK $75, and BATTERY YTX20CH-BS YUASA $140.  Neither of these is the type from the manual FTZ16-BS.
      from what I can tell... I think the only difference is the capacity with the $75 unit rated at 14 AH/10HR and the $140 unit rated at 18 AH/10HR ... which is the rating in the manual for the FTZ16-BS.  How much does this make a difference for nearly x2 the cost?
      And about the models/type numbers.... what is important to know ... they all end in "-BS" but are the other details relevant or just manufacturer naming?
    • By TomJulio
      Looking for two stock front wheels for 92 TRX300 2WD.   I think they are 6 x11" size.     
×
×
  • Create New...