Quantcast
Jump to content

Recommended Posts

Posted

Hey guys, havent been on here in quite some time, between work and everything else i havent had time to do anything. I sold the 400EX(wish i never did) and just bought a 1986 trx-350 for $150, guy said it had no spark, but i just bypassed the kill switch and it runs just fine. Its a beast for an old smaller ATV. Hopefully ill be on here more often, since i have some questions an this trx.

Jason

Posted

thanks guys. I sold it because i needed the $$ last year when i was between jobs, i miss the EX everyday lol. but i guess the ol TRX350 will have to work for now, cant complain to much about it lol

Posted
thanks guys. I sold it because i needed the $$ last year when i was between jobs, i miss the EX everyday lol. but i guess the ol TRX350 will have to work for now, cant complain to much about it lol

At least your riding !!:yes:

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By TomJulio
      My 1992 TRX00 recently stopped firing.  I understand this is a common problem. I have ordered an aftermarket CDI unit.    TJ
    • By Admin
      View File 1986-1989 Honda TRX350 Fourtrax TRX350D Foreman service manual
      1986-1989 Honda TRX350 Fourtrax TRX350D Foreman service manual
      Submitter Admin Submitted 03/08/2026 Category Honda ATV  
    • By toe420
      Hey everyone, I just picked up a 91 trx350 4x4 with a blown top end. I don't know what happened to the poor thing but the cam journals that were round are oval shaped now. I also bought a running engine from a 92 trx350 4x4 to swap into the 91. Is there anything in particular I should be checking while the engine is out and I have good access to it and the frame? 
    • Guest
      By Guest
      Hey all, new to the forum! I just bought a 1998 Kawasaki bayou 300, 4x4 not running. Initially I found no spark. Ended up playing with the plug wire (made sure plug top and wiring was touching) and got spark yesterday and the quad fired up off ether. Come to work on it today and now no spark again. Before I got spark and now today if I touch the plug after cranking I get shocked, and it will spark after I release the starter button. I was jumping the quad with a freshly charged car battery that has 12v while cranking. Cleaned out the kill switch and ignition button. All looks good. Purchased new plugs. They're are a lot of wires cut/ disconnected. But shouldn't matter if I got spark without them connected... 
    • By RGS
      1989 Moto 4 YFM350ERW intermittent spark.
      Quad has set for about 7 years and was running when parked.  When I replaced the battery and attempted to start it had no spark. 
       
      What I have done.  Followed troubleshooting in the manual. 
      1.       Coil failed the resistance check so I replaced it.  Still no spark.
      2.       I performed resistance checks on the stator and they all pass.
      3.       Found a bad rear brake stop switch and unplugged it and connected the wires in order to disable.  Now I have intermittent spark.  I believe that the issue is with either the stator or CDI and not sure which.
      1989 seems to be a transition year for electrical.  I can get new aftermarket CDI units for 87-88 and 90-94.  I cannot get ones for a 89.  I can get new stators for 87-89 and 90-95.  Looking at the schematics the wiring on my moto is closer to the 90 ones on the ATV side of the CDI and closer to the 87-88 on the stator side of the CDI.  Looking at part supply sources the stator housing is the same part # for all the years and looking at some of the stators on Amazon that have the dimensions on them both of the stators are the same size.
      What I am thinking of doing is to replace the stator and CDI with a 90-95 one as these parts are all readily available.   Does anyone know if this has been tried before and if there are any issues with doing this.  
       As a side note I also have a 1993 Moto 4 YFM350ER that has been sitting longer but it is located about 400 miles from me at this time.  By doing this change in addition to being able to get parts I will also have 2 ATV’s that are the same electrically. 
×
×
  • Create New...