Quantcast
Jump to content

Recommended Posts

Posted

Hey all,

First time poster here.  I have a '93 TRX300 with no spark.  Measuring 100 volts pulsing at the coil then declining down to 90, 80, 70, 60 and so on.  I assume it's the coil.  If there's voltage to the coil then everything else should be in working order, right?

Thanks for your help,

Deer Getter

  • Ajmboy changed the title to 1993 Honda TRX300 No Spark
Posted

I just fixed my 1993 Honda 300fw four trax.    Replaced the  i c m  ECM or what ever it is called.  Computer module.   Unit rides in a little harness right in front of the steering column.   Remove front cowling and replace  Very easy to do.   Was getting no spark.   Replace the module and bingo.  Cranked right up.

 

Posted
On 8/19/2018 at 9:04 PM, JSRinHSV said:

I just fixed my 1993 Honda 300fw four trax.    Replaced the  i c m  ECM or what ever it is called.  Computer module.   Unit rides in a little harness right in front of the steering column.   Remove front cowling and replace  Very easy to do.   Was getting no spark.   Replace the module and bingo.  Cranked right up.

 

Sweet, appreciate the insight.  I have a coil i'm going to try today, if that doesn't work i'll move to the ECM.  

Posted
On 8/15/2018 at 3:53 PM, Thelostsinner said:

I had a no spark issue and it ended up being a R/B wire that was not connected on the main harness - if you've shaken down everything else already might want to look for wiring gremlins.

Good call, there's always a chance Stuart Little got in there for a midnight snack...I'm hoping a new coil works for me, if not i'll download the service manual and move upstream to the computers and control modules.  

  • 2 weeks later...
  • 4 years later...
Posted

New CDI box was the fix 4 years ago.  Got a cheapish one on Amazon and boom I had spark.  It’s ran great for these last 4 years.  Funny you asked about this as just 3 weeks ago I again had no spark.  Engine turned over and ran for a few seconds then died.  After some diagnosis I figured out I lost spark again and replaced the CDI box and that fixed it.  The bad CDI box had a crack in it with what looked like a pretty significant short on the circuit board.  I guess at this point I’ll just plan on replacing the CDI every few years.  Thanks for the oven tip.  At around $20 for a new CDI I just went for a new part.  Read into this issue this time and found that no spark on these machines is usually the CDI box and sure enough that fixed it for me.  Hope this helps others.  

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By TomJulio
      My 1992 TRX00 recently stopped firing.  I understand this is a common problem. I have ordered an aftermarket CDI unit.    TJ
    • By TomJulio
      Looking for two stock front wheels for 92 TRX300 2WD.   I think they are 6 x11" size.     
    • By TomJulio
      I recently noticed my Fourtrax 2WD has 4WD wheels installed on the front.  The back spacing is significantly different than 2WD wheels and they are almost touching the strut springs and the tires actually do touch the springs..   So far, no luck locating 2WD wheels to correct this issue. 
    • By vlxerdon
      Hello from southeast Georgia. Was gifted a 2000 Yamaha bear tracker with out a carb or battery and looking like it had seen better days. Was told it had sat for about three years. Explained a lot. Put a carb on and a battery in and it started right up. Surprised the heck out of me  Anyhow as stated in my opening I am  78 years old with a very long motorcycle backgground but brand new to atv's. Anyone else out here from Georgia? Would like to meet up with some folks for a ride or two. Looks like a great site. Thanks for having me. 
      Don
    • Guest
      By Guest
      Hey all, new to the forum! I just bought a 1998 Kawasaki bayou 300, 4x4 not running. Initially I found no spark. Ended up playing with the plug wire (made sure plug top and wiring was touching) and got spark yesterday and the quad fired up off ether. Come to work on it today and now no spark again. Before I got spark and now today if I touch the plug after cranking I get shocked, and it will spark after I release the starter button. I was jumping the quad with a freshly charged car battery that has 12v while cranking. Cleaned out the kill switch and ignition button. All looks good. Purchased new plugs. They're are a lot of wires cut/ disconnected. But shouldn't matter if I got spark without them connected... 
×
×
  • Create New...