Join Today, It's Simple and FREE!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
By John Ford
i ordered a keihin carb for my 07 trx 90 and it fits nicely but the new cable they sent is way too long and i can't make it work. the old honda cable cap [that fits on top of the carb] is too small to fit. the keihin cap is approx 3/4 or 19mm. honda cap is more like 1/2 in. the keihin has a rubber boot on the cap where the throttle cable goes through . i don't know how to find the right length [most cites don't give the length]. i'm not sure how cables fit into that boot and do i need to add the length of the boot to the cable? the old honda cable is 28 inches total, but the cable movement is only approx 2'' which would not be enough to reach the actuator block on the keihin. looking to find a throttle cable compatible with the keihin. any help, please.
By Coral Breding
I loosened the allen bolts on the carrier and when I went to put my driver in the alot to pull back and tighten the chain, I noticed the holes were facing the front of the bike. I tried to slide a driver in and tighten the chain but the thing would not budge. I nearly ripped the tip off the driver in the slot. Any suggestions?
I've got a beater 84 honda trx that instantly starts smoking and gets really hot from it looks like the exhaust pipe coming out of the motor on the right side of the machine. When I fire it up it starts getting hot. Any suggestions would be awesome! Thanks so much
By Mark Walters
Hi guys. First post, hope you can help. As above 1991 Honda fourtrax. Starting, running fine until a few weeks ago. Used primarily to put my ski boat in the garage (put 2" ball on front). Any way, had just backed boat into garage, turned off to crank trailer wheel down, when I went to restart got nothing.
No neutral light, no headlights, no reverse light, would not turn over when start button pushed. It would crank and run when I jumped the contacts on the start relay. While running the neutral light will come on, although it is dim and flickers. Reverse light on when running and in reverse.
What I have done to this point:
1. Used jumper cable to ground battery (-) terminal to engine block thinking ground wire from battery to engine may be bad. No neutral light, no start.
2. Applied 12 volts to start relay. Got a loud click like it was making contact. I didn't have the battery/starter cables connected to the relay, but I am assuming it would have cranked at that time.
3. Disconnected neutral switch wire. Grounded neutral switch wire with jumper wire. No neutral light, no electric start.
At this point I am thinking ignition switch vs broken wire in the harness going to the neutral switch (due to dimness and flickering when running).
Any and all suggestions to help track down this issue are appreciated.
Recently Browsing 0 members
No registered users viewing this page.