Do you own an ATV or UTV? Join our Forum!
As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery. Registration is fast and you can even login with social network accounts to sync your profiles and content.
When running for a while the rancher will shut off without the fan turning on. We then took it to dealer where it was started and warmed up. The fan came on at the dealer so they then replaced the fuel filter and fuel pump. We got it back and ran good for a few days with the fan coming on when needed. Now its back to shutting off before the fan ever comes on. It seems like the time the fan should come on the bike shuts off. It will start after letting it sit for a few minutes. Any ideas of the problem?
Hello I’m wounding if any one knows if a clutch kit for a 2002 grizzly 660 is the same as 1998 Yamaha grizzly 600.
I am needing this due to miss-aligning while torquing nut after replacing belt and cleaning surfaces. So now I have to have new shaft and outside clutch part in pic with bushing and seal and bearings if possible.
So here's a topic for anything goes forum and to get a way from the china virus stuff...lol. Has anyone been noticing the small drips of news about ufos and the government confirming? President Obama has an interesting late night segment. How warm and fuzzy do you feel when an ex-gov official confirms objects in the sky they can't explain...
By marek porowski
I was wondering if anybody seen that problem and know what could cause it
it’s new to me 2018 Yamaha grizzly 700 with just over 4000km
it starts fine and runs great until it gets to normal running temp. Fan turns on few times and than it stalls. If I try to start it right after It won’t start but if I let it cool for a while it will start and run normal for a bit and than stall again.
so far I checked the stator output voltage and it’s around 22 volts AC between all 3 poles. I measured voltage on the battery while it runs and it’s around 14v so charging seems ok.
I’ve read somewhere that it could be the coil but I’m not sure how to test it
does anybody have any ideas what could that be ?
I recently purchased a 99 big bear 350 2x4 that was sitting for a while got it running and went to take it for a ride after about 10 minutes into the ride it stalled and wouldn't let me shift down into neutral tried rocking it back and forth but will not go into neutral...can anyone point me in the right direction on where to start?
Recently Browsing 0 members
No registered users viewing this page.