Jump to content


  • Content Count

  • Joined

  • Last visited

Community Reputation

4 Neutral

About Stitch196369

  • Rank
    Occasional Poster
  • Location Welland, ON, Canada

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

  1. Stitch196369

    Free Polaris ATV Manuals

    I am looking for a manual for a 1989 polaris trailboss 4x2. I believe it is either a 250 or 300
  2. I'd check to see if you picked something up in your clutch.when you remove the cover tap the clutch with a rubber Malloy while turning slowly.
  3. If and when you find that screw I would turn it all the way in while counting the turns. Don't turn in too tight just bottom it out. Start by turning the screw out 1-3/4 turns then start it. From there you can turn it out 1/4 turn at a time till you get a perfect running motor.
  4. Stitch196369

    Greets from Croatia

    Yes welcome to the group. I myself would like to see some pictures of one.
  5. Stitch196369

    1986 Yamaha Moto4 200 YFM200 Ignition problems! Please help!!

    On the old cb Honda's you had to sincronize the carbs for fuel air ratio.
  6. Hows your fuel air mixture
  7. Stitch196369

    Kazuma Dingo 150 and 250 Owners Manual

    How do I download this manual
  8. At the base of the engine cylinder there is usually in the casting on one side of the base the size of motor.
  9. Stitch196369

    New member with kazuma

    Hello all thanks for the add. I just got a Kazuma 150cc on a partial trade. Its all tore apart for paint but I'm a little suspicious about that. Could use a manual to reassemble and mor than likely do some repairs too.
  10. Stitch196369

    1986 Yamaha Moto4 200 YFM200 Ignition problems! Please help!!

    Check any wires near your throttle. My polaris trailboss was acting similar and I have a short that acts up whenever I use the throttle.
  11. Let me know if you have any luck. I just joined cause I got a 2004 Kazuma 150cc as part of payment for some work. Its partially dismantled.motors complete. I need to know how run the complete wire harness cause it had been removed to paint.