rappy97

There are more maps for more serious mods, such as a turbo, or N2o. From what I have read, there isnt enough adjustability on the Dobeck style controller.

I dont know about KFX's, but for the Raptor 700R's, the PCV is the best.

Well, I can not drive cars, but I can work on them:D Here are a couple I have worked on a bit. 1977 Porsche 928 Euro, the sixth one built. 1987 Porsche 928S-4, Perl.

I'll be there.

Yamaha totally copied Honda's fenders for the Raptor 125.

I just looked at your pics. Very nice bike! I like the look of the Honda fenders, esp. when they are race cut! I have had 2 Yamaha's and I beat the crap out of one, and it runs great lol. I have to push start it, and it has on flat tire, but it is super fun, since it is an 80.

I was going to get a duner YFZ, ported, FCR carb, cam... lots more (it had 65hp) but I like ice racing, which I wouldnt be able to do with it, due to a +6" swinger and a narrow axle. And, I can get into a smaller class when racing.

It is a 2006 Raptor 350.

Thanks. It is about 51" wide. Future mods include YFZ Front Shocks, 2001 Raptor 660 Rear Shock, HMF Full Exhaust, Renthal Bars, Grips, Sprockets, and Chain, HotRods 397 Stroker Kit, ModQuad Intake, QuadTech Seat Cover, GForce Axle & Rear Hubs.

I think a-arms, axle and shaving fenders do alot of good for the 400EX. It would be about $700 if you get FullFlight A-Arms and a GForce axle. Good Luck!

Okay, so after 12 hours of working at the shop, I got it, camber and what not is correct. The front is a bit lower than I would like, but it will work perfect for YFZ shocks, which are 1.5" longer.

Maier Hood My New YZ Shifter Riding View

It is on the left side of the carb, it is almost like a dipstick... I think.

I sounds like the A/F ratio is off.

Take a large screwdriver, and place it on the two bolts on the soleniod, it will spark some, but it should turn over the starter. If it doesnt, charge your battery, and check ALL your connections, clean everything, and make sure it is all hooked up properly. Good Luck!

I just ordered +3" a-arms and lines, Maier hood and a YZ250 direct shifter. I will post pics when the a-arms are on.

I got a Yamaha Badger 80 when I was 6 and started riding sleds at 5. Now I am hooked, it just never ends...

Nothing special, but it is a work in progress. I'm new to the forum, but I am very active on other forums. It has Tusk Nerf Bars, IMS Pegs, Tusk Billet Gas Cap, Aluminum Stem Caps, One Ind. Bar Pad, TinyTach Tachometer/Hour Meter, Rock Bumper, Rock E-Brake Block Off, RuKind Headlight Covers, Scott Handle Bar Grips and Tusk Handguards. I have +3" a-arms and braided lines coming. Thanks, Rappy97