Quantcast
Jump to content

  • Join Today, It's Simple and FREE!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.


Recommended Comments

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Tagged Content

    • By thegipper
      Have replaced, Carb, fuel pump, CDI, plug, coil,fuel filter. Will crank but not srt. Getting spark and battery is fully charged 12.6V
      Any suggestions????
       
      Thanks
    • By Wali
      I was riding my 400ex one day and when i shut it off to put it in the garage i tried to start it put again to drive it into the garge and it wouldnt start.I put a compression tester on it and its like 30 psi with out throttle and 0 psi WITH THROTTLE.
      when i put my finger over the hole it fell likes its pulling my finger in more then its pushing it out 
       
      Has good spark.When i took it into the shop the said it had 1oz of oil in it and a tiny pit of metal shaving(TINY BIT LIKE 30 flakes)
      When i try to pull start (push start/roll start) it made a not normal sound  and wouldnt stay running.
      If my bottom end is blow why would it still turn over fine,
      Are my valves siezed or not working properly 
      or is my timing off causeing valves to not open in correct order with fire 
      PLEASE HELP all help is appreciated 
    • By Mark Walters
      Hi guys.  First post, hope you can help.  As above 1991 Honda fourtrax.  Starting, running fine until a few weeks ago. Used primarily to put my ski boat in the garage (put 2" ball on front).  Any way, had just backed boat into garage, turned off to crank trailer wheel down, when I went to restart got nothing.  
      No neutral light, no headlights, no reverse light, would not turn over when start button pushed.  It would crank and run when I jumped the contacts on the start relay.  While running the neutral light will come on, although it is dim and flickers.  Reverse light on when running and in reverse.
      What I have done to this point:
      1.  Used jumper cable to ground battery (-) terminal to engine block thinking ground wire from battery to engine may be bad.  No neutral light, no start.
      2. Applied 12 volts to start relay.  Got a loud click like it was making contact.  I didn't have the battery/starter cables connected to the relay, but I am assuming it would have cranked at that time.  
      3. Disconnected neutral switch wire.  Grounded neutral switch wire with jumper wire. No neutral light, no electric start. 
      At this point I am thinking ignition switch vs broken wire in the harness going to the neutral switch (due to dimness and flickering when running).
      Any and all suggestions to help track down this issue are appreciated.
      Thanks
       
    • By Ineedabrew
      Hello all,
      I have brought an 84 TRX 200 back to life and unfortunately whomever dug into it first removed the two trim pieces that go around the gas tank.  I was thinking someone on the site may have an old parts bike with these pieces lying around.....  If so, drop me a message and we can make a deal.  I just want to complete the bike!
      Thanks,
      Jason


    • By Connor Tuftin
      I have a 1988 300 Honda FourTrax, All wheel drive.
      My brother and I were fixing up this quad. We put a brand new battery and fuses in and it was running fine until we put the quad into reverse. As soon as it was put into reverse all of the electrical cut out and power wasn't making it to the head unit anymore and both of the brand new fuses popped. We figured there might have been a short from the starter or solenoids, but they are all working properly. At this point we don't know where to start looking for where the short could be. I'm just wondering if anybody has had the same issue or knows of similar issues that could cause these electrical shorts?
  • Check these out!




×
×
  • Create New...