Quantcast
Jump to content


need help 2001 scrambler 90 spark


lskivers

Recommended Posts

had spark lost spark found 2 wire that if i barly rub them together spark comes back but when i twist them together for solid contact spark go's away the wire that i found must have went to the switch that some one cut off the bike cause they lost the key the wires one is black with blue stripe and the other is the grond black if any one has one of these 4 wheelers could you please look at the wireing behind the switch and help me out or if you have the manual email me the wire diagram PLEASE!!!

Link to comment
Share on other sites

  • 5 weeks later...

this thing is drivin me insane people i got a new complete wireing harness and key switch ,coil,battery the thing has a very weak spark the spark plug gap has to be set under.005 to get a spark ive even held on to the plug and it shocks me but nothin like it should and=y suggestion would be greatly appriciated thanks LOUIE SKIVERS:aargh::aargh::aargh::aargh:

Link to comment
Share on other sites

Well it sounds to me like you are not getting a hot enough spark out of the coil.

Check all your cnnections and grounds (bolts to any frame connections)

Even though it's new, your coil or cdi could be defective.

You could have a bad plug wire, did you change that?

Link to comment
Share on other sites

This is not a repeat thread i got the wireing strait this is another problem

icon8.gif Still need help with my boys scrambler 90

I GOT BRAND NEW WIRE HARNESS KEY SWITCH AND COIL AND CID CHECKED ALL THE GROUNDS BUT NOW I CANT GET A SPARK UNLESS THE GAP UN THE PLUG IS UNDER .005 ALLMOST SHUT COMPLETELY I HELD THE END OF PLUG BETWEEN MY FINGERS AND I SHOCKS ME BUT ONLY VERY MILD SHOCK KINDA LIKE A 9VOLT battery ON YOUR TOUNGE GETTIN PRETTY PISSED THE TOP END HAS BEEN COPLETELY REDONE AND WIREING IS ALL BRAND NEW ANY SUGGESTIONS WOULD BE GREAT THANKS LOUIE SKIVERSarghh.gifarghh.gifarghh.gifrealmad.gifrealmad.gif:rea lmad:

icon8.gifneed help with my boys scrambler 90

this thing is drivin me insane people i got a new complete wireing harness and key switch ,coil,battery the thing has a very weak spark the spark plug gap has to be set under.005 to get a spark ive even held on to the plug and it shocks me but nothin like it should and=y suggestion would be greatly appriciated thanks LOUIE SKIVERS

Looks like a repeat to me.

Link to comment
Share on other sites

Agreed, you actually have three separate threads for the same issue. They have all been merged into the first thread you started. I understand that your situation has progressed, but it is still the same issue. Also, you also have said essentially the same thing in three separate posts. I deleted two of those. Please try not to repeat yourself. It is easier for every one if you keep things clean and consolidated.

Link to comment
Share on other sites

  • 11 months later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By Mhatayas
      My uncle bought a Baja 250, 2006. Knew there was no spark since the get go. He don't know anything about quads so is getting me to help him try to get it running...
       
      battery is bad so I connected battery charger to it to crank it over , cranks over well , but no spark .... 
      Lights and everything work fine , but with each crank over using the e start switch , the display reads 999 888 777 666 ... Right down to 000 and repeats itself . 
       
      He managed to get a parts bike , I changed over the CDI and the coil and the stator from the parts bike and there was another black box by the voltage regulator I changed over ... I used my multimeter to confirm as much as I could works , it's hard without knowing which wires are which , and I cannot find any diagrams online for this bike ? 
       
      Do you think it could be the Killswitch? There's so many wires coming from there I don't know where to start . Also I should mention it appears the fan on the front of the bike has been taken off (the wires have been cut too ) 
       
      If this bike sparked it would run . The previous owner said he parked it one day and it just wouldn't start after.
    • By ethie
      Hi All
      I have a 2012 Coleman 500 Outfitter that keeps fouling out the plug within 10-15 minutes 
      not sure where to start
    • By Uglyside38
      I have a 1988 Quadrunner 250 2wd. My brother in law sold it to my son for $20...had been sitting outside for several years. Got it home and had it running in about 30 mins. Ran it a bit and then went to looking at the carb as it was having trouble idling. Was getting it pretty close, then started losing spark...Also, it wouldn't start up every time...only about 1 in 5 tries. Anyway...now, it has what I can only describe as "intermittent" spark. I can get 1 light spark right when the start button is pressed and sometimes one when it's released...but none while cranking. 🤷‍♂️

      I have replaced the spark plug, ignition coil/wire, and traced wires best I can. I noticed a couple frayed wires at the pickup coil where it enters the case. So, now I have the cover off, stator and pickup coil out and trying to test the coil. I do have about 114 ohms resistance for pickup best I can tell. And I can read minute voltage when I drag a magnet across it. Could it still be bad? Can a bad ignition switch/button cause this? (I did have the switch off to oil the choke cable)...pulling rope makes no difference though...any ideas or help would be greatly appreciated!!! It's the intermittent part that's throwing me off! 

    • By Gwbarm
      I have been exploring all the options available, so many, its hard to choose. I have kind of narrowed it down to the Honda Pilot, Subaru Outback, and Kind of looking at the Outlander, although its a little small,  the new one is nice looking. Just wondering if anyone has any recommendations or gripes with any of these rides. I have driven Jeeps for the past 25  years and they have been great, but their price point has gotten to high. Expieriences good or bad would be helpful. Thanks!
    • By DrtyGrlKristin
      Just thought I'd start a new thread for newbies to the site!
      If you're new here, tell us who you are, where you're from and what you ride!!!
      Lets get to know each other a little better shall we?
      I'm not new to the site, obviously, but...
      I'm Kristin from Denver!!! I ride a 2008 Yamaha Rhino. She's my muddy baby!!!!!! Several aftermarket parts on her. She's good to me! We try and ride every weekend. This weekend we're off to MOAB! :woot:
×
×
  • Create New...