Quantcast
Jump to content

Recommended Posts

Posted

My 2005 500 TBX 4x4 has only 400 miles on it, and it is down AGAIN!! This time when I start it, fires up, idles fine, warm it up, and get it out of barn, and give it gas, NO POWER!! It starts to back fire, and flat out barly goes over 5mph. Changed the plug, cleaned the carb, but still no good. I hope that someone has had this problem, or can point me in the right direction. The closest dealer is far away, and I dont have 2-3-400.00 dollars to take it to a dealer. If someone has any ideas, or has a question, PLEEAASE let me know. Thanks.

Posted

you can either take your gas tank off and empty it in to a pail, or shut the petcock off and remove the fuel that way in a line into a container. the fuel lines will come off by twisting them sideways back and forth as you pull at the ends where they connect. probably there are no clamps holding them on, just friction fit. just blow thru the lines to make sure they are clear and you can use something the same inside diameter to remove any scale.

you might also want to unscrew the petcock and make sure the fuel screen isn't clogged also....

Posted (edited)

I really appreciate your help, but I don't know what a petcock is. Is there a link, or a website, that explains this, since I don't expect you to sit and try to explain in type. But if there is a link, or you know where this is already explained, that would be a big help. Is the petcock like a fuel shut off valve maybe? I do know where the fuel lines go into the non-electric fuel pump, and there are no clamps there I don't think. I think there is one from the tank, and 2 to the engine, 1 to carb, and one vac. I believe. I have a Artic Cat repair manual, the online version, but there is very limited info on the fuel system, in regards to the fuel pump. Maybe I will try YouTube, and get lucky, unless there is a better site that you know of. Thanks for youre help.

Edited by bones
typo
  • 1 month later...
Posted

The first problem is that usually some part of the carb was put together wrong, the plug if fouled, or the gas is bad. I usually siphon out the gas from the tank I know 06 and up is not gravity fed by guess is the 05 falls in the same boat so the is no fuel shut off.

Put some new gas in it and run the required mix of sea foam in the gas and let it idle for a while to work its way through the carb then check and clean the plug. At least that is where I would start.

  • 2 weeks later...
  • 2 weeks later...

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Forum Topics

    • By rjsummer
      Just picked up an 84 LT185 ATV, I understand there was an accessory add  on that gave it electric start, anyone have any info about that kit? 
    • By Rockbottom
      2008 400 big bear was running now will not start
      have power to relay, in neutral, press start have power to starter but nothing happens starter does not turn
      i have good ground at battery to frame and added ground from wire harness to frame beside batter/ frame ground
      blue white wire to cdi has power with key on
      I believe the neutral lock out is working since is was before i shut it down
      if i put  it in gear and hit the start button with key on the relay does not click or send power the starter
      The 3 wires at the relay have power with key on
      What should i test next?
      thanks ahead
    • By Mister907
      Hi guys, I have a 2004 big bear 400. Last winter while plowing the driveway, I heard a loud pop from the left side of the engine. It continued to run as I looked for leaky fluid, but then died shortly after backing it up and won’t start now. The oil light comes on when I try to start it, no noise or anything else. 
      No blown fuses that I can find.
    • By Brent Wright
      What's a good size to start a 10 year old on?
    • By HeWasRidinDirty
      The one I need to replace has a 2 wire plug coming out of it. Searching eBay I see tons of them with only 1 wire . WTH???

×
×
  • Create New...