Search the Community
Showing results for tags 'starting'.
-
I know this tooic has been addressed by many, I’ve looked through many forums and pages. I did not find anything like the problem i have. I have a 2007 Kingquad 450. I have a new fully charged battery. When i turn the key, the dash flashes and seems to struggle before getting fully lite. We can hear a small relay near the computer clicking, i think it is the fuel pump relay. When i turn off the engine kill switch and press the starting button relays click and all the power shuts off, i turn the key off, engine kill switch then start over, power is there. Atv will start with pull start, but not elextricly. if i try to use my winch, all power cuts and engine dies. Can anyone tell me what it may be? or has anyone fsced an issue like this before?
-
I have a 1999 Sportsman 500, it was running fine, than started to lose power in the winter, I adjusted the idle screw and away I went, than a few weeks ago it died, I have found that i am flooding the engine, compression was at 70PSI and due to the compression release mech. i assume i am good as it compared to the same PSI on a 2000 sportsman 500 i have. i cannot start the atv unless i go full throttle and it starts an runs for about 30 sec than dies, again it is flooded. i ordered a new carb off ebay as i could get one for around $40. put that in same issue, i have checked the timing, (good), valves out of adjustment i adjusted to .006 still same issue, i have found the exhaust lobe and rocker arm to have some wear, i have ordered new ones, but am looking for any other input in this area as well. would the exhaust cam and rocker arm cause the engine to flood? i have used a bore scope and the piston liner has good cross hatching still? any input would be great.
-
Hi Guys, I'm a newbie but pretty handy with a DMM (controls technician). I have been fighting a junker quad i picked up as a project bike, was assured it would run if I replaced the battery and cleaned the carb. I replaced the battery, rebuilt the carb with a OEM kit. FIxed all my switches and foul played circuitry from the last guy.... So I could get it to start long enough to test the quad, it seems okay from a trans/engine point. However I couldn't get the carb adjusted to idle to save my life with the idle air screw or the thumb screw on the card for the slide. I took it to a friend who is much more familiar with yamaha and quads and he double checked my carb rebuild all was fine, he adjusted the float to make the fuel not overfill which i missed. He pulled the air intake, got it started and couldn't get it to idle with or without air filter. We started looking at the spark plug (new) and he tested it with a spark plug clamp meter, tested good, pulled it and grounded and it had spark but he felt it was weak. I order a working used oem coil to try the easy things first. When I ohm out the coil on the quad with my Fluke i'm seeing .4 ohms on primary (ground lug to male connector) and 18K ohms on secondary (inside boot to ground lug). Seems like this forum is full of bear trackers so I'm hoping someone has some ideas to help me figure where to go with this. His thought was he know I ave fuel and he knows I have air, spark would be next. I have spark but possibly weak. Thanks
- 23 replies
-
- bear tracker
- idle
-
(and 1 more)
Tagged with:
-
i have a older honda 350 cc quad that seems to start and other days will not.spark seems to be gone and there when it does run.I checked newer coil odd a older yet Honda but no help and idea I going to find the serial number as forget the year but believe around 1995 to 1997 year besides that great quad but cant run it so great this way and need it for chores around the acreage. Any help would be great. Ive check all fuses as well as the fusable ling which was fine until I screwed with it now need to buy another as have it wired not so safe.I handy but now have copd which takes away the brain power some.Any help would sure be appreciated
-
I put on a new stater , How would my Yamaha raptor 350 act if the starter clutch went out ??? Please help !!! There is no metal in oil . Its like when you hit the starter button nothing ? Any ideas ???
-
I have 2000 Yamaha bear tracker 250 - igniton relay and starter relay both were replaced also the neutral switch indicator was replaced-- bike will not show light on for neutral or start when button is pushed
- 2 replies
-
- bear tracker
- neutral
-
(and 2 more)
Tagged with:
-
I have a 2006 Polaris 500 sports man and having trouble starting it and keeping it running.
-
My 2006 Prairre will only start with a shot of starting fluid. Any ideas or suggestions of what might be the problem?? Thanks.
-
I have a 1995 Yamaha 350 big bear and I am having trouble starting it. You can hear the solenoid click but starter motor won't engage. Should I be looking at the starter motor or solenoid? Any suggestions are appreciated.
-
I am a new member and was hoping i could get some good info on why my 2002 yamaha blaster atv will not run. the ignition light will not stay on when i try to start it. i put new plugs, cleaned gas. when i pulled it with my pick up with someone on it , it would start and run, now it will not even start by pulling it now. any one out there with some good advice?
-
i have a 06 yfz450 that ran fine a few days ago but now it will only turn over and wont start dose any body have idea on what it could be,ive heared it could be the valves(hoping its not) any help will do
-
I just got a 2001 ds650, has a Ron woods cdi box, pro circuit t4 exhaust, k&n filter, a few other things , anyway it ran perfectly for me tons of power no weird sounds looks brand new, I rode it around in the woods today for about 3 hours fine no problems at all, I turned it on and off about 15 times and it started everytime no issue, than towards the end it just shuts off and won't star back up, it turns over but won't start, I thought I was out of gas maybe even though it looked like a quarter tank at least so I put it on reserve and nothing still, I thought maybe I had flooded it so I left it alone for five hours and still wouldn't star and now my frigging battery is dead, anyone know what it could be? It has never not started before it always runs perfect, than nothing, the lights and fan and everything still came on but it just would not start, it wanted to, I'd appreciate any help or tips at all, on anything about the ds, thanks
-
Hello everyone, I am a newbe and just bought my first ATV, it was super fun for the first week. Worked great. Then it would just not start. I pulled the carb and cleaned it out thinking something was blocked and it all looked ok. I changed the spark plug and have spark but it will not fire. I tried to use starter fluid but it still will not start. Any one have any ideas.
-
I saw this in a previous post a while back. SHOW YOUR PAGE OFF! I'm starting this up again and want to see some exciting member pages! I just did mine pretty quick but I like it! So design and change your pages and post here when you're ready and maybe we'll get a poll going!! Oh yeah, Hit me up to be your friend!! Here is my page: http://www.quadcrazy.com/quadmaniac Let's GO!