Quantcast
Jump to content

oxidized_black

Members
  • Posts

    10,696
  • Joined

  • Last visited

  • Days Won

    38

Everything posted by oxidized_black

  1. much easier !!! you'll see when the new u-joint will just slip in and clip it ...
  2. there are going to be little circle clips holding the u-joint on, if you're lucky it might all fall apart, or you might have to do some hammering on the centers of the u-joint itself to get it to move. heat is always good sometimes too if you're careful, just a small propane torch for plumbling....
  3. i would check the diff fluid level and make sure there is fluid there, there is going to be a little play in the driveshaft, and the cv joints too. if you jack the front up, you can move the tires, wiggle like to make sure the bearings are good, and tie rods and ball joints. what is making you think it's the driveshaft and or u-joint? just noise? or unbalanced?
  4. good to know, thanks Ajmboy. not in need of one yet, but the big bear is grunting and it's almost time to replace it, but i don't want to spend a fortune with warn...
  5. i have the 2005 manual, searching online it is supposed cover up to 07, but there are no supplements in this manual... you are more than welcome to it. when you get to the page, login tab is in the top right corner, then after login, top middle page and click the 'folders' icon. suzuki has its own folder inside there ...
  6. hello and greetings to you !! hope you have fun here !!
  7. both manual are here
  8. i have a service manual here but im not sure if it's the 300, pretty sure it is, but need your email address to send it to you ....
  9. slipped abit, but are in top 10 !! just click on the link to vote !!
  10. nothing asbestos anymore for quite a few years ....
  11. from the shop manual, it looks like alot of work. if you want the service manual ... go here : www.yousendit.com login : [email protected] pass : romy1961 1987 - 1997 Yamaha Big Bear YFM 350 Service Manual
  12. it was a dry day for me, gatorade only LOL
  13. LOL... yah, the other part of it is alot better, we were there to stay out of the wind. the gravel pit is starting back up again from the winter so there will be more hills, right now there are only a couple and some holes
  14. if you drop some gas down the cylinder will it start? or if you use some spray starter fluid?
  15. i have it if you want to send me your email address in a private message, i'll send it right out to you
  16. what year is your bayou billy123?
  17. i looked last night for the specs but couldn't find them for the stator. there are two connectors coming from the stator/block, and i know there is one connection with 2 wires that you test is for the stator. this is an example from a 1995 - 2004 Yamaha Wolverine YFM 350 Service Manual.
  18. right on, a buddy of mine just picked up a used polaris last night, not as good a deal as your bro-in-law though ... that's awesome !!
×
×
  • Create New...