Quantcast
Jump to content

  • Join Today, It's Simple and FREE!

    As a member, you can post in our forums, upload your photos and videos, use and contribute to our downloads, create your own member page, add your ATV events, and even start your own ATV club to host your own club forum and gallery.  Registration is fast and you can even login with social network accounts to sync your profiles and content.


Photo Information for In line Fuel Filter


Recommended Comments

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Add a comment...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Similar Tagged Content

    • By Hayden Pahnke
      Bought brand new petcock and carbetator, turned air fuel needle out 2 turns and machine still acts like its starving 4 fuel on top end. Any ideas?
    • By Brad Leeson
      What's going on party people? First, thank you for allowing me the opportunity to be here. I recently purchased a 2005 yrs 450 and have yet to run the bike at full throttle. The bike fires up, idles, seems like everything runs fine except a little popping when you let off the throttle or until you hit 5th gear. It runs strong; no bogging or sluggishness until you hit 4th gear and open it up. Then it begins to act like it's out of gas or the about to be out. I can pull over and sit for 5-10 min and it runs strong again until you open the throttle. I have the carb off the bike to clean and wrote down a list of factory and what I found installed. I also listed other key factors and hope someone can help and explain. I'm new to the scene and have no prior mechanical experience but my theory is worst case scenario I have to take it to the shop anyway so why not learn. I actually enjoy it. Lol. Thanks a million. Hope to get back on the trails soon. 

    • By Paul Maple
      I have a 1999 Sportsman  500, it was running fine, than started to lose power in the winter, I adjusted the idle screw and away I went, than a few weeks ago it died, I have found that i am flooding the engine, compression was at 70PSI and due to the compression release mech. i assume i am good as it compared to the same PSI on a 2000 sportsman 500 i have. i cannot start the atv unless i go full throttle and it starts an runs for about 30 sec than dies, again it is flooded. i ordered a new carb off ebay as i could get one for around $40. put that in same issue, i have checked the timing, (good), valves out of adjustment i adjusted to .006 still same issue, i have found the exhaust lobe and rocker arm to have some wear, i have ordered new ones, but am looking for any other input in this area as well. would the exhaust cam and rocker arm cause the engine to flood? i have used a bore scope and the piston liner has good cross hatching still? any input would be great.
    • Guest huntingstill
      By Guest huntingstill
      k I would like to take my one person off road go cart and turn it into a sand rail LIFT it new engine and transmission make it so you have to shift w/ a clutch and all the fun stuff a car has
    • By johncb
      My mother has a 05 John Deere 650 trail buck ext and someone told me that can am made the atv for JD. I was wondering what model can am it would be so I can find a service manual for it.
  • Check these out!




×
×
  • Create New...