Search the Community
Showing results for tags ' 400'.
-
Can anyone tell me where the fuses are on a 2005 Polaris Sportsman 400. The winch suddenly stopped working. I put a tester on it and its not getting any juice. Please help! (I dont even know if the machine has a fuse for that)
-
Have a 2003 kfx 400 decided to go for a ride and after 10 minutes it started to bog down after giving it gas.It starts right up and idles like it was new.It bogs down after reving it up will run all day at idle.The only warning i got was it did backfire a few weeks back and conked out drove it back to the garage and parked it.What could this possible be.Spark plug? Cloged carb? or electronics. Could use some help .
-
Hey guys, Im new here but I recently Picked up a '99 Foreman 400 that apparently just had a top end rebuild. It blows white smoke like crazy and ticks/knocks and seems to follow the rpm's. I haven't done to much trouble shooting yet, It starts and runs like a champ and has good compression. I was just wondering if anyone has any suggestions as to where to go. Oh ya the top end rebuild the guy did was according to him he honed the cylinder and replaced the piston and rings, my fear is an ovaled cylinder?
-
Having a problem on my 2006 400. LCD display will not power up. Check fuses under seat seem ok. Is there any inline fuses I should know about....Any help?
-
Hi, I have just purchased a 2002 Yamaha Kodiak 400 I think, the vin has worn off and I have located an engine number I think it is J312E-004674, could anyone tell me where the engine number might be please
-
Any ideas on what would make a coil not fire? She was running fine, then began slow start. Now wont start at all.
-
Hi Folks MY Ltf 400 has power and electric start turns motor over, but wont start... seems no spark im told stalled in paddock and wont start again any suggestions please
-
:confused:need a repair manual or help in what to look for thank you Bill for you muddober to make clear to you the neutral light and the gear light do not light up win shifting fuses are good Iuse my CAt for hunting im dissable the atv is my leag s thank you
-
Hi guys Does anyone have a link to a service manual for the 2008 KingQuad fs 400 4x4. I would be very happy to get my hands on a file Thanks. :-)
-
I am looking for a downloadable manual for a 2000 Arctic Cat 400 4x4 that I just purchased
-
I just got a big bear 400 on a trade. They say the mechanic told them the oil pump quit and it is junk. The machine looks almost new and has never left the old man's farm. It will not turn over but I have yet to determine if that is due to the issue or the guy not putting it back together right. I think he was trying to snow the old guy. Do these oil pumps quit? What is typical? I am a Honda 2 stroke guy by nature but I love my timberwolf but the wife has claimed it and figured this may be its big brother and be mine around the farm.
-
I have a really dumb question. My big bear came half apart and I am not sure how the timing chain guide is supposed to sit in there. I have the entire top end cleaned, bored, new piston, gaskets, etc. I do not see anywhere in any manual or thread where it shows how the chain guide is installed or held on place????? Also should it be the same height as the other side???
-
I have a couple of questions again please. In cleaning the carb i took the needle valve out.... it had a string on it and a rubber ring and a small washer... I need to know for sure how these go back because they fell out of the carb when i took the needle valve out and I am not unsure of how they go back in I think the spring first slides onto the needle valve, but what comes next if so the washer or the rubber O ring? Next I noticed the breather that i purchased does not set tightly into the hose that comes out of the carb would that keep it from idleing correctly? cause i can put something against the hose and it trys to idle? right now though i have the float off cause gas is pouring out of the carb when i try to start it... Thank you in advance
-
Hi: I am looking for some help. I just bought a 2004 Can Am 400 quad that had sat for 2-3 years. I can start it if I spray some gas into the carb but it only runs a few seconds. I haven't been able to get it to continue. Any advice on what the problem might be and how I might follow it would be very much appreciated. It had about a quart of gas in the gas tank when I got it. I siphoned that out and put in new gas. This is my first quad so I'm quite new to this.
-
I just bought a Used Kodiak, that I will be using mainly for Ice fishing, and it ran fine at the guys house started right up and everything seemed fine. I Got home and Hopped on to take it off the trailer, i Pressed the brake and hit the button and it turned over, fired up and then dies. (it starts cold so I was not concerned.) When I hit the electric start again there was no noise or anything, Just the coolant indicator light illuminates when ever I hit the button. I cycled through the shifter (park, reverse neutral, and drive,.) and then hit the button again, with the same result. I noticed the park light does not illuminate, but the reverse and Neutral do. I tried starting it in Neutral, and again nothing it just illuminates the coolant light. SO am I doing something wrong? I finally put it in neutral and pushed it off the trailer, and started googling. I have not seen anything on this being a problem or even what it would indicate. Any help appreciated.
-
Does anybody have the service manual or the link to one for this bike? Thanks guys
-
Bike will start manually but not with electric start. Starter relay just clicks. Is there a way to test before i just go by a new starter relay?
-
Since day one of owning the Kodiak I have not been able to shift gears going up steep roads nor down steep roads, it will shift gears fine going straight on a road though. But if i start out going up a steep road in 1st gear no matter how i try while moving it will not let me shift into 2nd gear ..etc... unless I stop then I can change into 2nd gear its the same way if I am going down a steep hill what ever gear I am in I have to stay in that gear till I stop and change to another gear. but again it is fine if I am driving on a straight road is this normal? if not is there a way to adjust it maybe a linkage to adjust to where it will shift easier when I use my foot to try and shift uphill or downhill.. I recently drove a small kawaski 220 and it shifts easily going up a steep road and down it without having to stop to shift. Would appreciate some insight from someone that knows about these type of atvs when it comes to shifting them. Thank you
-
Hi guys, I recently bought a 2004 polaris sportsman 400 that is missing a radiator guard and was wondering whether this one from 600 would work. Thanks Polaris Sportsman 600 4x4 2003 Front Bumper Radiator Guard 9507 | eBay If not what would work, I know that sportsman 500 works but I can't find any either.
-
Anyone know how many links in the drive chain to the front wheel drives on the 1995 sport 400 2 stroke if it makes a difference. thanks in advance freight:GEEK:
-
Hello! I have a 1995 sport 400 4wd, after cleaning the carb it starts and runs but when I turn the key or switch the kill switch it wont shut off. not all the time though.any suggestions on where to start? there is a ground cable that's on the frame above the carb that's not connected and would love to know where that goes. thanks in advance freight
-
Here's one for ya. Why won't my speedometer work? I've had this machine for a few months now and finally got it going, after replacing the piston and boring the jug to .020" over but would like to know if any of you guys have had problems with your speedo and possibly where to start looking. Is it a mechanical or electrical issue? Don't know where to start...
-
Why can't I find an operator's manual for this machine? Seems like the 2 stickies above skip right over this machine. Can anyone help?